Sea Water Strainer - Clean/Inspect
The sea water strainer must be clean in order to provide proper cooling. Clean the sea water strainer more frequently if the vessel is being operated in water which is shallow or dirty. Refer to the OEM recommendations for more information about inspecting and cleaning the sea water strainer.
The sea water strainer has screens that can be rotated by the hand wheels. Rigid scrapers remove buildup from the screens when the hand wheels are rotated. The strainer must be cleaned when the strainer is under positive pressure.
- Make sure that the strainer is under positive pressure.
- Open the drain valve in order to purge debris from the sump of the strainer.
- Rotate the hand wheels several times.
- Allow the debris to be flushed out of the strainer.
- After the debris is flushed, close the drain valve.
Show/hide table
Illustration 1 | g00655760 |
Sea water strainer |
Caterpillar Information System:
3114, 3116, and 3126 Engines for Caterpillar Built Machines Fuel Injection Control Linkage - Install
Customer Communication Module (CCM) for Diesel Engines Initialization for Remote Connection with Modem
3114, 3116, and 3126 Engines for Caterpillar Built Machines Fuel Injection Control Linkage - Remove
3406E, C-10, C-12, C-15, C-16 and C-18 On-highway Engines 0110-11 Very High Coolant Temperature (61)
Customer Communication Module (CCM) for Diesel Engines Initialization for Direct Connection
3406E, C-10, C-12, C-15, C-16 and C-18 On-highway Engines 0110-00 High Coolant Temperature Warning (61)
3406E, C-10 and C-12 On-highway Engines 0105-11 Very High Intake Manifold Air Temperature (64)
Customer Communication Module (CCM) for Diesel Engines Password - Enable and Disable
Customer Communication Module (CCM) for Diesel Engines Reference Material
3406E, C-10 and C-12 On-highway Engines 0105-00 High Intake Manifold Air Temperature Warning (64)
3406E, C-10, C-12, C-15, C-16 and C-18 On-highway Engines 0100-11 Very Low Oil Pressure (46)
3512 Industrial Engine Maintenance Interval Schedule
3406E, C-10 and C-12 On-highway Engines No Diagnostic Code Detected (55)
3608 Engine Engine Oil - Change
SR500 Generators Voltage Connections
3608 Engine Heat Exchanger - Clean
3608 Engine Fuel System Primary Filter - Clean
3608 Engine Fuel System Secondary Filter - Replace
3608 Engine Engine Mounts - Inspect
3608 Engine Reference Material
3126B Engine for Caterpillar Built Machines Exhaust Temperature Is Too High
3508B, 3512B, and 3516B High Displacement Generator Sets Generator Start-up Checklist
3114, 3116, and 3126 Engines for Caterpillar Built Machines Unit Injector - Install
3054B Industrial Engine General Information