Ensure that all of the warning signs are legible. Clean the warning signs or replace the warning signs if the words cannot be read or if the pictures are not visible. When the warning signs are cleaned, use a cloth, water, and soap. Do not use solvent, gasoline, or other harsh chemicals to clean the warning signs. Solvents, gasoline, or harsh chemicals could loosen the adhesive that secures the warning signs. The warning signs that are loosened could drop off of the engine.
Replace any damaged warning signs or missing warning signs. If a warning sign is attached to a part of the engine that is replaced, install a new warning sign on the replacement part. Any Caterpillar dealer can provide new warning signs.
Do not work on the engine and do not operate the engine unless the instructions and warnings in the Operation and Maintenance Manual are understood. Proper care is your responsibility. Failure to follow the instructions or failure to heed the warnings could result in injury or in death.
The warning labels that may be found on the engine are illustrated and described.
The warning label for ether is located on the top, the front, the rear, or the side of the engine.
Illustration 1 | g00640926 |
Do not spray starting aids such as ether into the air inlet. Such use could result in an explosion and personal injury.
Illustration 2 | g00107406 |
The warning label for the clutch is located on the clutch housing (if equipped).
Illustration 3 | g00107407 |
Rotating gears can cause entanglement of fingers or entanglement of hands. Do not service this component without first reading the operator manual.