Water Pump - Install
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Clean surface (7).
- Inspect the condition of the O-ring seals. Replace the seals, if necessary.
Show/hide table
Illustration 2 g00614173 - Install the O-ring seal on water pump (5).
- Position water pump (5) on the front of the engine. Install bolts (6).
Show/hide table
Illustration 3 g00614170 - Connect hose (3) to water pump (5) and to the water temperature regulator housing. Install clamps (4).
- Install hose assembly (2) to the water pump elbow.
- Install V-belt (1) and adjust V-belt (1). Refer to the Specifications Module, "Belt Tension Chart".
- Fill the cooling system with coolant to the correct level. Refer to the Operation and Maintenance Manual for the correct filling procedure.
Show/hide table
Illustration 1 | g00614182 |
End By:
- If equipped, install the special fan drive mounting. The mounting may be one-piece or two-piece. Refer to Disassembly and Assembly, "Fan Drive Mounting Group - Remove and Install".
- Install the belt tensioner. Refer to Disassembly and Assembly, "Belt Tensioner - Remove and Install".
Caterpillar Information System:
3034 Marine Engine Water Temperature Regulator Housing
3126 Truck Engine Military Water Pump - Remove
G3612 and G3616 Engines Valve Lifter - Assemble
G3612 and G3616 Engines Valve Lifter - Disassemble
G3612 and G3616 Engines Valve Lifter - Install
Generator Set Load Sensor Installation Requirements
G3612 and G3616 Engines Valve Lifter - Remove
3524B Engine for Caterpillar Built Machines Crankshaft - Install
3126B Engines for Caterpillar Built Machines Crankshaft Wear Sleeve (Rear) - Remove - If Equipped
Electronic Modular Control Panel II (EMCP II) For MUI Engines Troubleshooting Diagnostic Codes
3512B Marine Auxiliary Engine Flexible Coupling
3524B Engine for Caterpillar Built Machines Crankshaft - Remove
3524B Engine for Caterpillar Built Machines Camshaft Bearings - Remove
3500B Engines Camshaft Bearings - Install
3126B Engines for Caterpillar Built Machines Water Pump - Disassemble
SR4B Generators Winding - Test
SR4B Generators Resistor - Test
C-15, C-16 and C-18 Truck Engines Water Temperature Regulator - Remove and Install
3126B Engines for Caterpillar Built Machines Water Pump - Assemble
3054B Industrial Engine Reference Material
3114, 3116 and 3126 Engines Air Inlet Heater - If Equipped
3114, 3116 and 3126 Engines Little or No Valve Lash
3114, 3116 and 3126 Engines Loss of Coolant
SR4B Generators Leads - Connect