Housing (Front) - Install
Installation Procedure
- Clean the joint face on front housing (4) with 8T-9011 Component Cleaner .
Show/hide table
Illustration 1 | g00612359 |
- Apply 4C-9500 Quick Cure Primer to the joint face. Allow the primer to dry for at least three to five minutes.
- Apply 1U-8846 Sealant to the joint face. Spread the sealant uniformly. Front housing (4) must be installed within ten minutes of applying the sealant.
Note: Do not allow the 1U-8846 Sealant to seal the main oil passage on front housing (4) .
- Position front housing (4) on the cylinder block.
- Install the bolts that fasten front housing (4) to the cylinder block and the engine oil pan.
- Position belt tightener (3) and install two bolts (2) .
- Position the front engine support and install five bolts (1) .
Show/hide table
Illustration 2 | g00615717 |
- Install any external components, if equipped.
End By:
- Install the camshaft. Refer to Disassembly and Assembly, "Camshaft - Install".
- Install the crankshaft front seal. Refer to Disassembly and Assembly, "Crankshaft Front Seal - Install".
- Install the crankshaft vibration damper. Refer to Disassembly and Assembly, "Vibration Damper and Pulley - Remove and Install".
Caterpillar Information System:
C-9 Engines for Caterpillar Built Machines Exhaust Manifold
3524B Engine for Caterpillar Built Machines Crankshaft Main Bearings - Remove
3126B Engines for Caterpillar Built Machines Housing (Front) - Remove
3500 and 3500B High Displacement Engines for Caterpillar Built Machines Flywheel Housing - Install
SR4B Generators Glossary
3500 and 3500B High Displacement Engines for Caterpillar Built Machines Flywheel Housing - Remove
C-9 Engines for Caterpillar Built Machines Crankshaft Seals
3612 and 3616 Engines Engine Oil Filler and Oil Level Gauge - Remove and Install
SR4B Generators Component Descriptions
SR4B Generators General Information
C-15, C-16 and C-18 Truck Engines Engine Oil Filter Base - Remove
3612 and 3616 Engines Turbocharger - Install
3612 and 3616 Engines Engine Oil Filler and Oil Level Gauge - Remove and Install
3500B Engines Camshaft
C-15, C-16 and C-18 Truck Engines Engine Oil Filter Base - Install
G3304 and G3306 Engines Crankshaft
C-9 Engines for Caterpillar Built Machines Water Temperature Regulator Housing
3126B and 3126E On-highway Engines Fuel Transfer Pump - Remove
3612 and 3616 Engines Crankcase Explosion Relief Valve - Remove and Install
3524B Engine for Caterpillar Built Machines Crankshaft Main Bearings - Install
3500 Engines for Caterpillar Built Generator Sets Vibration Damper
C-9 Industrial Engine Flywheel Housing
3512B Marine Auxiliary Engine Housing (Front)
3126B and 3126E On-highway Engines Front Cover - Remove