Removal Procedure
| NOTICE |
|---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
| NOTICE |
|---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
- Remove the bolts that hold valve mechanism cover (1) to valve mechanism cover base (2) .
 | |
| Illustration 1 | g00820158 |
- Remove the seal from the valve mechanism cover.
Installation Procedure
| Required Tools | |||
| Tool | Part Number | Part Description | Qty |
| A | 4C-9612 | Silicone Sealant | 1 |
| NOTICE |
|---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Position valve mechanism cover (1) and the seal on valve mechanism cover base (2). Cut the seal to length. Apply Tooling (A) on both sides of the seal joint.
| | |
| Illustration 2 | g00820158 |
 | |
| Illustration 3 | g00611545 |
Bolt tightening sequence for the valve mechanism cover (A) Rear (B) Front | |
- Install the bolts. Tighten the bolts in a numerical sequence to a torque of 9 N·m (80 lb in).