Commercial Oils
If the Caterpillar Transmission/Drive Train Oil is not used, then commercial oils meeting the Caterpillar TO-4 specification should be used.
Show/hide table
NOTICE |
---|
Failure to follow this recommendation can cause shortened transmission/drive train life due to material incapability and inadequate frictional requirements for disk material. |
The following lists of commercial oils have been previously announced as having Caterpillar TO-4 performance.
Show/hide table
COMMERCIAL OILS     | |
---|---|
COMPANY     | OIL BRAND NAME (1)     |
Mobil Oil Co., Fairfax, VA     |
Mobil Trans HD     |
D-A Lubricant Co., Indianapolis, IN     |
D-A Torque Fluid 4     |
Universal Motor Oils Co. Inc., Wichita, KS     |
Dyna-Plex 21CTO-4 Transmission Oil     |
Mitsubishi Oil Co., Japan     |
Mitsubishi TO-4 Oil     |
Texaco Lubricants Co., Houston, TX     |
Texaco Transmission Drive Train Oil (SAE 10W and 30 only)     |
Behnke Lubricants Inc., Milwaukee, WI     |
Jax Powertran Fluids     |
Minuteman Lubricants Inc., Cabol, PA     |
Minuteman TO-4 Special Lubricant     |
Shell Oil Company, Worldwide     |
Shell Donax TC Oil     |
Dryden Oil Company, Baltimore, MD     |
Dryden Trans C TDTO     |
Chevron USA, Richmond, CA     |
Chevron Drive Train Fluid HD (SAE 10W and 30 only)     |
Black Bear Company, Inc., Long Island, City, NY     |
Black Bear Transmission Oil TO-4     |
CITGO Petroleum Corporation, Tulsa, OK     |
CITGO Transpower Fluid     |
Pennzoil Products Company, Houston, TX     |
Pennzoil Power-Tranz TO-4     |
Valvoline Inc., Lexington, KY     |
Valvoline DT Transmission Fluid     |
CONOCO Inc., Houston, TX     |
Conoco Power Drive 44     |
Exxon Company, Houston, TX     |
Exxon Torque Fluid     |
Amoco Oil Company, Oak Brook, IL     |
Amoco HD TransOil     |
GC Quality Lubricants, Inc., Macon, GA     |
GC Cat Trans30 (SAE 30 only) GC Cat Gear 50 (SAE 50 only)     |
Show/hide table
( 1 ) | Unless the oil viscosities are stated otherwise, all of the oils that are listed are SAE 10W, 30 and 50. |
The following table contains a list of other oils which can be used.
Show/hide table
COMMERCIAL OILS     | |
---|---|
COMPANY     | OIL BRAND NAME     |
Agip     | BLASIA 220     |
Aral Dego TU 220     |
Degol BG 220     |
AVIA     | AVILUB RSX 220     |
Castrol Alpha ZN 220     |
Alphasyn T 220     |
DEA     | Trion EP 220     |
ELF ELF EPONA Z 220     |
REDUCTELF SP 220     |
FINA     | GIRAN L 220     |
Fuchs     | RENEP AWD 220     |
Klüber     | LAMORA 220     |
Mobil Mobilgear SHC 220     |
Mobilgear 630     |
TOTAL     | CARTER EP 220     |
Tribol Tribol 1510/220     |
Tribol 1100/220     |
Note: The commercial oils that are listed in Tables 1 and 2 does not constitute an approval by CIPI for usage of these oils. The list is intended to provide you with sources that may meet TO-4 performance levels.
Caterpillar Information System:
Electronic Modular Control Panel II (EMCP II) For MUI Engines CID 100 FMI 4 Pressure Sensor (Engine Oil) Voltage Below Normal - Test
C-10 and C-12 Truck Engines Control Valve (Compression Brake) - Test
Electronic Modular Control Panel II (EMCP II) For MUI Engines CID 100 FMI 3 Pressure Sensor (Engine Oil) Voltage Above Normal - Test
C-10 and C-12 Truck Engines Slave Piston Lash - Adjust
3176C and 3196 Engines for Caterpillar Built Machines Vibration Damper - Check
3408E and 3412E Engines for Caterpillar Built Machines Flywheel Housing - Inspect
Electronic Modular Control Panel II (EMCP II) For MUI Engines CID 100 FMI 2 Pressure Sensor (Engine Oil) Incorrect Signal - Test
3306C Engines for Caterpillar Built Machines Flywheel - Inspect
3126B Marine Engine Auxiliary Water Pump
Electronic Modular Control Panel II (EMCP II) For MUI Engines Fault Identification
3500B and 3500B High Displacement Generator Set Engines Engine Monitoring System
3406E and 3456 Generator Set Engines Flywheel Housing - Remove and Install
C-10 and C-12 Truck Engines Solenoid Valve (Compression Brake) - Test
Electronic Modular Control Panel II (EMCP II) For MUI Engines CID 110 FMI 2 Temperature Sensor (Engine Coolant) Incorrect Signal - Test
G3606 and G3608 Engines Gas Pressure Regulator - Assemble
3406E and 3456 Generator Set Engines Gear Group (Front) - Remove
G3606 and G3608 Engines Air Inlet Choke - Install
3408E and 3412E Engines for Caterpillar Built Machines Battery - Test
Electronic Modular Control Panel II (EMCP II) For MUI Engines CID 110 FMI 3 Temperature Sensor (Engine Coolant) Voltage Above Normal - Test
3408E and 3412E Engines for Caterpillar Built Machines Charging System - Test
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Water Temperature Regulator - Remove and Install
3408E and 3412E Engines for Caterpillar Built Machines Excessive Bearing Wear - Inspect
C-10 and C-12 Industrial Engines Excessive Engine Oil Consumption - Inspect
3408E and 3412E Engines for Caterpillar Built Machines Increased Engine Oil Temperature - Inspect