Fuel Injection Nozzles - Remove
Removal Procedure
Start By:
- Remove the fuel injection lines. Refer to Disassembly and Assembly, "Fuel Injection Lines - Remove and Install".
Show/hide table
| NOTICE |
|---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
| NOTICE |
|---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
- Remove two bolts (1) from the cylinder head.
Show/hide table
 | |
| Illustration 1 | g00545199 |
- Remove clamp (2) .
- Remove fuel injection nozzle (3) and the seat washer that is on the end of fuel injection nozzle (3) .
Show/hide table
 | |
| Illustration 2 | g00545200 |
- Remove dust seal (5) and spacer (4) .
Caterpillar Information System:
3408E and 3412E Engines for Caterpillar Built Machines Engine Oil Cooler - Remove
3054 Engine for Caterpillar Built Machines Fuel Injection Lines - Remove and Install
SR4 HV and SR4B HV Generators Glossary
3412E and C30 Marine Engines Front Power Take-Off (FPTO)
3054 Engine for Caterpillar Built Machines Fuel Transfer Pump - Assemble
3408E and 3412E Engines for Caterpillar Built Machines Electric Starting Motor - Remove and Install
3406C (PEEC III) Truck Engines Engine Vibration Troubleshooting
3054 Engine for Caterpillar Built Machines Fuel Transfer Pump - Disassemble
G3606 and G3608 Engines Water Pump - Assemble
3412E and C30 Marine Engines Air Starting System
G3606 and G3608 Engines Water Pump - Disassemble
G3606 and G3608 Engines Water Pump - Install
3054 and 3056 Industrial and Generator Set Engines Fuel Injection Nozzles - Install
3054 and 3056 Industrial and Generator Set Engines Fuel Injection Pump - Remove
3408E and 3412E Engines for Caterpillar Built Machines Engine Oil Cooler - Install
3054 and 3056 Industrial and Generator Set Engines Fuel Injection Pump - Install
3054 Engine for Caterpillar Built Machines Turbocharger - Remove
3054 Engine for Caterpillar Built Machines Turbocharger - Install
3054 Engine for Caterpillar Built Machines Turbocharger - Disassemble
G3606 and G3608 Engines Water Pump Seal - Remove
3054 Engine for Caterpillar Built Machines Turbocharger - Assemble
3054 and 3056 Industrial and Generator Set Engines Inlet Manifold - Remove
3612 and 3616 Fast Vessel Engines Hourly Performance Log
3606 and 3608 Engines Cooling System Operation