Fuel Injection Pump - Install
Installation Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Inspect the condition of the gasket for the fuel injection pump. Replace the gasket, if necessary.
- Install the gasket and fuel injection pump (5) .
Note: Align marks (4) that are on fuel injection pump (5) and the timing gear cover.
Show/hide table
Illustration 1 | g00545262 |
- Install the key.
- Install three nuts (6) that hold fuel injection pump (5) in position.
- Install fuel line (7) on fuel injection pump (5) .
- Engage the gear with the fuel injection pump.
- Install the lockwasher and nut (3) on the gear in the front housing. Tighten the nut to a torque of 78 N·m (58 lb ft).
Show/hide table
Illustration 2 | g00545258 |
- Install cover (2) and four bolts (1) on the front of the engine.
Show/hide table
Illustration 3 | g00545256 |
- Set the timing of the fuel injection pump. Refer to the Testing and Adjusting Module for the correct procedure.
End By:
- Install the fuel injection lines. Refer to Disassembly and Assembly, "Fuel Injection Lines - Install".
- Install the water pump. Refer to Disassembly and Assembly, "Water Pump - Install".
Caterpillar Information System:
3408E and 3412E Engines for Caterpillar Built Machines Engine Oil Cooler - Install
3054 and 3056 Industrial and Generator Set Engines Fuel Injection Pump - Remove
3054 and 3056 Industrial and Generator Set Engines Fuel Injection Nozzles - Install
3054 and 3056 Industrial and Generator Set Engines Fuel Injection Nozzles - Remove
3408E and 3412E Engines for Caterpillar Built Machines Engine Oil Cooler - Remove
3054 Engine for Caterpillar Built Machines Fuel Injection Lines - Remove and Install
SR4 HV and SR4B HV Generators Glossary
3412E and C30 Marine Engines Front Power Take-Off (FPTO)
3054 Engine for Caterpillar Built Machines Fuel Transfer Pump - Assemble
3408E and 3412E Engines for Caterpillar Built Machines Electric Starting Motor - Remove and Install
3406C (PEEC III) Truck Engines Engine Vibration Troubleshooting
3054 Engine for Caterpillar Built Machines Fuel Transfer Pump - Disassemble
3054 Engine for Caterpillar Built Machines Turbocharger - Remove
3054 Engine for Caterpillar Built Machines Turbocharger - Install
3054 Engine for Caterpillar Built Machines Turbocharger - Disassemble
G3606 and G3608 Engines Water Pump Seal - Remove
3054 Engine for Caterpillar Built Machines Turbocharger - Assemble
3054 and 3056 Industrial and Generator Set Engines Inlet Manifold - Remove
3612 and 3616 Fast Vessel Engines Hourly Performance Log
3606 and 3608 Engines Cooling System Operation
3054 and 3056 Industrial and Generator Set Engines Inlet Manifold - Install
3054 Engine for Caterpillar Built Machines Inlet and Exhaust Valve Springs - Remove and Install
G3606 and G3608 Engines Water Pump Seal - Install
3612 and 3616 Fast Vessel Engines Engine Mounts - Check