Exhaust Manifold - Remove and Install
Removal Procedure
Start By:
- Remove the turbocharger. Refer to Disassembly and Assembly, "Turbocharger - Remove".
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Remove four nuts (1) from exhaust manifold (2) .
Show/hide table
Illustration 1 | g00542541 |
Typical example |
- Remove exhaust manifold (2) and the gasket from the cylinder head.
Installation Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Inspect the condition of the gasket. Replace the gasket, if necessary.
Show/hide table
Illustration 2 | g00542541 |
Typical example |
- Install the gasket and exhaust manifold (2) on the cylinder head.
- Install four nuts (1) on exhaust manifold (2). Tighten the plated nuts to a torque of 44 N·m (32 lb ft). Tighten the nuts that are not plated to a torque of 50 N·m (37 lb ft).
End By: Install the turbocharger. Refer to Disassembly and Assembly, "Turbocharger - Install".
Caterpillar Information System:
3408E and 3412E Engines for Caterpillar Built Machines Hydraulic Pump Drive
G3408 and G3412 Engines Exhaust Manifold
3412E, C30 and C32 Marine Engines Turbocharger - Install
3508, 3508B, 3508C, 3512, 3512B, 3512C, 3516, 3516B and 3516C Engines Caterpillar Monitoring System System Self Test
3508, 3508B, 3508C, 3512, 3512B, 3512C, 3516, 3516B and 3516C Engines Caterpillar Monitoring System System Schematic
3508, 3508B, 3508C, 3512, 3512B, 3512C, 3516, 3516B and 3516C Engines Caterpillar Monitoring System Initial Troubleshooting Procedure
3508, 3508B, 3508C, 3512, 3512B, 3512C, 3516, 3516B and 3516C Engines Caterpillar Monitoring System Glossary of Terms
G3606 and G3608 Engines Aftercooler - Assemble
G3606 and G3608 Engines Aftercooler - Disassemble
3054 Engine for Caterpillar Built Machines Flywheel Housing - Remove and Install
3612 and 3616 Fast Vessel Engines Warranty Information
3054 Engine for Caterpillar Built Machines Crankshaft Rear Seal - Install
G3606 and G3608 Engines Actuator (Heinzman) - Remove and Install
3054 Engine for Caterpillar Built Machines Fan - Remove and Install
3606 and 3608 Engines Pressure Switch
G3606 and G3608 Engines Turbocharger - Remove
3054 Engine for Caterpillar Built Machines Fan Drive - Remove
3606 and 3608 Engines Fuel Shutoff
3054 Engine for Caterpillar Built Machines Fan Drive - Install
G3606 and G3608 Engines Turbocharger - Install
3054 Engine for Caterpillar Built Machines Electric Starting Motor - Remove and Install
C280 Marine Engines Fuel System Operation
3606 and 3608 Engines Air Inlet and Exhaust System Operation
G3606 and G3608 Engines Turbocharger - Disassemble