3608 Engine Caterpillar

Illustration 1	g00526298

(1) Tighten the nut that fastens the rack to the lever to the following torque. ... 17 ± 7 N·m (13 ± 5 lb ft)

(2) Set the shaft end play between the lever and the flange assembly to the following value. ... 2.0 ± 0.5 mm (0.08 ± 0.02 inch)

(3) Flange assembly

Bore in the bearing in the flange assembly ... 19.044 ± 0.007 mm (0.7498 ± 0.0003 inch)

Diameter of shaft at bearing ... 19.00 ± 0.02 mm (0.748 ± 0.001 inch)

(4) Bracket assembly

Bore in bearing in the bracket assembly ... 19.044 ± 0.007 mm (0.7498 ± 0.0003 inch)

Diameter of shaft at bearing ... 19.00 ± 0.02 mm (0.748 ± 0.001 inch)

Tighten flange assembly (3) and tighten cover assembly (5) before tightening bracket assembly (4).

(5) Cover assembly

Bore in bearing in the cover assembly ... 19.00 ± 0.02 mm (0.748 ± 0.001 inch)

Diameter of shaft at bearing ... 19.00 ± 0.02 mm (0.748 ± 0.001 inch)

Illustration 2	g00513898

(6) Set adjustable rod to the following value between centers of the rod ends. ... 248.5 mm (9.78 inch)

Illustration 3	g00513899

(7) Bearings should be pressed to the following depth. ... 13.3 ± 0.3 mm (0.52 ± 0.01 inch)