- Wheel Loader
- 986H (S/N: 986188-UP; L8S1-UP)
- 986K (S/N: MH8172-UP; NL8260-UP; SWH1-UP)
Introduction
Revision History | |
Revision | Summary of Change |
01 | Changes were made to serial numbers and the solution section |
The problem that is identified below does not have a known permanent solution. Until a permanent solution is known, use the solution that is identified below.
Problem
The 393-5152 Pump Control Valve Gp may experience reduced performance on the machines listed above. The reduction in performance is due to the spools inside 393-5152 Pump Control Valve Gp seizing or sticking.
Solution
Caterpillar is aware of this problem and is recommending the following interim solution. In case of failure, replace the failed 393-5152 Pump Control Valve Gp with the same new part.
Note: Remove and inspect 483-9966 Hose As, 483-9965 Hose As, 376-5951 Hose As, 376-5950 Hose As, and 449-4411 Hose As and clean as needed.
Note: Obtain an oil sample for analysis. Refer to Contamination Control Guidelines, SEBF8447, "Filtration Procedure for Excavator Hydraulic Oil" as needed.