- Telehandler
- TL1055D (S/N: ML51-751; MNT1-179)
- TL1255D (S/N: ML71-720; MYW1-156)
- TL642D (S/N: ML81-471; MLG1-162)
- TL943D (S/N: MLD1-164; MLJ1-395)
- TL1255D (S/N: ML71-720; MYW1-156)
Reference: Service Magazine, M0073550, Procedure to Improve Door Window Striker and Latch Alignment on Certain Telehandlers
Reference: Service Magazine, M0081564, A Shim Procedure to Adjust the Cab Door Window Latch Is Available on Certain Telehandlers
Description Of Change: New orientation for the door holder in the cab door group is now used on the machines listed above. The new orientation will increase the durability and service life of the door holder.
Adaptable To: The following changes are adaptable to the products within the listed serial numbers, and are effective with all products after the listed serial numbers.
Required Parts List | ||||
---|---|---|---|---|
Item | Qty | New Part Number | Part Name | Former Part Number (1) |
1 | 2 | Shim | ||
2 | 1 | Cab Window Gp | ||
3 | 1 | Door As | ||
4 | 1 | Plate | ||
5 | 4 | Screw | ||
6 | 2 | Door Holder | ||
7 | 1 | Strap |
(1) | The former part number listed is for reference only and may differ. |
(2) | After failure only |
Note: If the window is replaced, refer to M0073550 and , M0081564 for alignment and shimming instructions.
Rework Procedure
The existing door holder may be reused if it has not failed.
- Remove the four 495-6147 Screw (5) from the two 329-3664 Door Holder (6).
Show/hide table
Illustration 3 g06193268 New orientation of the door holder
(6)329-3664 Door Holder - Flip both door holders by 180 degrees as shown in Illustration 3.
- Install the new, shorter 515-9909 Strap (7).
- Reinstall the screws.
- Check the door opening. The door should open approximately 90 degrees with the re-oriented door holders and strap.
Illustration 1 | g06193262 |
(1) (2) (3) |
Illustration 2 | g06193264 |
Detailed view of area A (4) (5) (6) (7) |