M314F, M316F, M318F, M320F, M322F, MH3022, MH3024 and MH3026 Wheeled Excavator Engine Supplement Caterpillar

Removal Procedure

Start By:

1. Remove the exhaust elbow.

Show/hide table

Personal injury or death may result from failure to adhere to the following procedures. Fuel leaked or spilled onto hot surfaces or electrical components can cause a fire. Clean up all leaked or spilled fuel. Do not smoke while working on the fuel system. Turn the disconnect switch OFF or disconnect the battery when changing fuel filters.

Show/hide table

Personal injury can result from hot coolant, steam and alkali. At operating temperature, engine coolant is hot and under pressure. The radiator and all lines to heaters or the engine contain hot coolant or steam. Any contact can cause severe burns. Remove cooling system pressure cap slowly to relieve pressure only when engine is stopped and cooling system pressure cap is cool enough to touch with your bare hand. Do not attempt to tighten hose connections when the coolant is hot, the hose can come off causing burns. Cooling System Coolant Additive contains alkali. Avoid contact with skin and eyes.

Show/hide table

Hot engine components can cause injury from burns. Before performing maintenance on the engine, allow the engine and the components to cool.

1. Drain the coolant. Refer to Operation and Maintenance Manual, "Cooling System Coolant (ELC) - Change" for the correct draining and filling procedure.
   Show/hide table

   Illustration 1	g03865720

2. Remove bolts (1) and cover (2).
   Show/hide table

   Illustration 2	g06004716

3. Remove all clips (4). Disconnect soot sensors (3) and (5).
   Show/hide table

   Illustration 3	g06004751

4. Disconnect harness assembly (6). Disconnect hose assemblies (7), (8), and (9).
   Show/hide table

   Illustration 4	g06004914

5. Remove bolt (10) and reposition hoses (11).
   Show/hide table

   Illustration 5	g06004839

   Show/hide table

   Illustration 6	g06008586

6. Attach a suitable lifting device to clean emissions module assembly (12). The weight of clean emissions module assembly (12) is approximately 160 kg (350 lb).

7. Remove mounting bolts (13) and clean emissions module assembly (12).
   Show/hide table

   Illustration 7	g06008613

8. Disconnect harness assembly (14).
   Show/hide table

   Illustration 8	g06008633

9. Disconnect harness assembly (15).
   Show/hide table

   Illustration 9	g06008661

10. Attach a suitable lifting device to clean emissions module (16). The weight of clean emissions module (16) is approximately 109 kg (240 lb). Remove bolts (17) and clean emissions module (16).
    Show/hide table

    Illustration 10	g06008716

11. Disconnect nitrogen oxide sensors (19). Remove bracket assembly (18).

Installation Procedure

1. Install clean emissions module (16) in the reverse order of removal.

   1. Apply Tooling (A) to the threads of nitrogen oxide sensors (19).

   2. Tighten nitrogen oxide sensors (19) to a torque of 50 ± 10 N·m (37 ± 7 lb ft).

   3. Tighten soot sensors (3) and (5) to a torque of 1.2 ± 0.2 N·m (10.6 ± 1.8 lb in).