| NOTICE |
|---|
|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products. Dispose of all fluids according to local regulations and mandates. |
 |
|
Personal injury can result from the sudden release of high pressure oil. Be sure the engine has been shut off for a minimum of five minutes to be sure that the accumulator pressure is zero. The accumulator is filled with dry nitrogen. Do not loosen or remove the valve or cap from the top of the accumulator. A purge screw at the bottom of the accumulator can be used to release the pressure that is left in the system. |
|
|
Personal injury can result from hydraulic oil pressure and hot oil. Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system. Make sure all of the attachments have been lowered, oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand. |
| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Release the system pressure.
- Connect the steering frame lock.
- Engage the parking brake.
Show/hide table
Illustration 1 g01379928 - Remove guard (1).
Show/hide table
Illustration 2 g01379938 Show/hide table
Illustration 3 g01379959 - Disconnect fitting (3). Loosen clamp (2).
- Loosen clamp (4). Remove accumulator (5).
- Repeat Step 5 through Step 6 for the remaining accumulator.
|
|
Personal injury or death can result from improper accumulator charging. Dry nitrogen is the only gas approved for use in the accumulator. Charging the accumulator with oxygen gas will cause an explosion. This danger will not happen if nitrogen cylinders with standard CGA Compressed Gas Association, Inc.Number 580 connections are used. When ordering nitrogen gas, be sure that the cylinders are equipped with CGA Number 580 Connections. Do not use color codes or other methods of identification to tell the difference between nitrogen and oxygen cylinders. Never use an adapter to connect your nitrogen charging group to a valve outlet used on both nitrogen, oxygen or other gas cylinders. Be sure you use dry nitrogen (99.8 % purity). |
| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Install accumulator (5). Tighten clamp (4). Tighten clamp (2). Connect fitting (3).
- Charge the brake accumulator.
- Repeat Step 1 through Step 2 for the remaining accumulator.
Show/hide table
Illustration 6 g01379928 - Install guard (1).
- Disengage the parking brake.
- Separate the steering frame lock.
| |
| Illustration 4 | g01379959 |
| |
| Illustration 5 | g01379938 |