Engine Oil Filter Base - Remove and Install
拆卸步骤
Show/hide table
| 所需工具 | |||
| 工具 | 零件号 | 零件描述 | 数量 |
| A | 185-3630 | 带式扳手总成 | 1 |
Show/hide table
| 注意 |
|---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
Show/hide table
| 注意 |
|---|
在进行检验、保养、测试、调整及维修产品期间，必须小心以确保装好排放出的油液。 在打开任何舱室或解体任何储有液体的部件之前，要准备好合适的容器收集液体。 有关收集和盛接 Cat 产品上油液的适用工具和用品，请参阅专门出版物, NENG2500, "代理商维修工具目录"。 按照当地法规和要求处置所有液体。 |
- 使用工具 (A) 拆下机油滤清器 (4) 。
Show/hide table
 | |
| 图 1 | g01256974 |
- 断开软管组件 (1) 。
- 拆下将机油滤清器底座 (3) 固定到缸体上的螺栓 (2) 和垫圈。 拆下发动机机油滤清器底座 (3) 。
安装步骤
- 安装发动机机油滤清器底座 (3) 。
- 按照数字顺序将螺栓 (2) 依次上紧到 28 ± 7 N·m (21 ± 5 lb ft) 的扭矩。
- 按照数字顺序将螺栓 (2) 依次重新上紧到 28 ± 7 N·m (21 ± 5 lb ft) 的扭矩。
Caterpillar Information System:
C7 Engine for Caterpillar Built Machine Exhaust Manifold - Remove and Install
C7 Engine for Caterpillar Built Machine Turbocharger - Remove and Install
C7 Engine for Caterpillar Built Machine Unit Injector Hydraulic Pump - Remove and Install
2014/05/30 The Handrail Group has been Improved on the 793F Off-Highway Truck {7256}
735C, 740C EJECTOR and 745C Articulated Trucks Backup Alarm Always On
824K Wheel Dozer, 825K Soil Compactor and 826K Landfill Compactor Machine Systems Service Brakes
735C, 740C EJECTOR and 745C Articulated Trucks Backup Alarm Always Off
2014/06/23 New Spacers for Transmission Shafts Two and Three are Now Available for Certain Motor Graders {3063, 3155, 3170}
C7 Engine for Caterpillar Built Machine Electronic Unit Injector Sleeve - Remove and Install
735C, 740C EJECTOR and 745C Articulated Trucks Symptom Troubleshooting
980M and 982M Wheel Loaders Power Train, Steering, Braking, Hydraulic, and Machine Systems Steering Control - Control System
586C Site Prep Tractor Machine Systems Cab Tilt Cylinder
586C LRC Site Prep Tractor Cooling System Water Temperature Regulator - Replace
C7 Engine for Caterpillar Built Machine Engine Oil Cooler - Remove and Install
C7 Engine for Caterpillar Built Machine Water Pump - Remove and Install
C7 Engine for Caterpillar Built Machine Crankshaft Rear Seal - Remove and Install
586C LRC Site Prep Tractor Braking System - Test
C7 Engine for Caterpillar Built Machine Gear Group (Front) - Remove and Install
C7 Engine for Caterpillar Built Machine Housing (Front) - Remove and Install
C7 Engine for Caterpillar Built Machine Rocker Arm and Shaft - Remove and Install
C7 Engine for Caterpillar Built Machine Camshaft - Remove and Install
Procedure for Installing Improved GPS Antenna Mast Back Support and Clamps on Certain Off-Highway Trucks{733B} Procedure for Installing Improved GPS Antenna Mast Back Support and Clamps on Certain Off-Highway Trucks{733B}
C7 Engine for Caterpillar Built Machine Camshaft Bearings - Remove and Install
C7 Engine for Caterpillar Built Machine Engine Oil Pan - Remove and Install