Check the Brake Group Retaining Bolts on Certain R2900G and R3000H Load Haul Dump Machines {4251, 4267}
- Load Haul Dump
- R2900G (S/N: JLK1-UP; NLK1-UP)
- R3000H (S/N: RCM1-UP; RCY1-UP)
Introduction
The problem that is identified below does not have a known permanent solution. Until a permanent solution is known, use the solution that is identified below.
Problem
Field service reports indicate that 9S-1366 Bolts on the brake group may become loose or fall out.
Show/hide table
Illustration 1 | g03097278 |
View of brake and wheel assembly (1) (2) Wheel assembly |
Solution
Monitor each brake group at every regular machine service for loose or missing 9S-1366 Bolts (1). In the event of any loose or missing 9S-1366 Bolts (1) follow the instruction below.
- Remove all 9S-1366 Bolts (1), one bolt at a time. Clean each bolt and bolt hole. Install with correct Loctite adhesive and torque to specification. Refer to RENR8558, for installation procedure and specifications.
- Replace any loose or missing 9S-1366 Bolts (1) with a new 9S-1366 Bolt.
- Submit a Dealer Solution Network (DSN) ticket quoting CPI number 276302
- Request a Tier 1 representative, transfer your ticket to an available Tier 2 representative for Caterpillar Underground Mining, Base Machine.
Reference: Disassembly and Assembly, RENR8558, "Final Drive and Brake - Assemble".
Caterpillar Information System:
424B Backhoe Loader Sampling Interval and Location of Sampling Valve
773G and 775G OFF-Highway Trucks Engine Supplement Gear Group (Rear) - Install
12M Motor Grader Engine Supplement Aftercooler - Remove and Install
773G and 775G OFF-Highway Trucks Engine Supplement Gear Group (Rear) - Assemble
2012/07/25 A New Fastener for Certain Compact Track Loader and Skid Steer Loader Equipped with Electric Coupler and or Self Level Harness. {5057, 6129}
773G and 775G OFF-Highway Trucks Engine Supplement Gear Group (Rear) - Disassemble
12M Motor Grader Engine Supplement Radiator Guard and Support, Aftercooler, Hydraulic Oil Cooler, and Radiator - Remove and Install
773G and 775G OFF-Highway Trucks Engine Supplement Gear Group (Rear) - Remove
12M Motor Grader Engine Supplement Fuel Filter (Secondary) and Fuel Filter Base - Remove and Install
12M Motor Grader Engine Supplement Fuel Priming Pump and Water Separator - Remove and Install
The Final Drive Thrust Washers May Fail on Certain 16M Motor Graders{4050} The Final Drive Thrust Washers May Fail on Certain 16M Motor Graders{4050}
MH3049 Material Handler C9 Engine Supplement Electric Starting Motor - Remove and Install
RM-500 Soil Stabilizer Emulsion Spray System - Clean
2012/06/25 The Drive Shaft of the Final Drive Group Has Been Improved on Certain Motor Graders {4050, 4056}
12M Motor Grader Engine Supplement Radiator - Remove and Install
910K and 914K Compact Wheel Loaders Engine Supplement Pressure Sensor (Mass Air Flow) - Remove and Install
910K and 914K Compact Wheel Loaders Engine Supplement Pressure Sensor (Mass Air Flow) - Remove and Install
2384C, 2484C, 559C and 579C Knuckleboom Loaders Machine Systems Main Control Valve - Disassemble
2384C, 2484C, 559C and 579C Knuckleboom Loaders Machine Systems Main Control Valve - Assemble
2012/07/20 The Rod Assembly for the Platform Enclosure Group Has Been Updated on Certain Track-Type Tractors and Pipelayers {726A}
12M Motor Grader Engine Supplement Rear Chassis Support - Remove and Install
2012/07/31 New Fluid Sampling Valve Is Now Used in the Hydraulic Oil Cooler Lines Group on 777G Off-Highway Trucks {1374, 5057}
Software Installation Instructions of the Plus+1 Service Tool for Caterpillar P1STC Is Available for Caterpillar Paving Products {0785} Software Installation Instructions of the Plus+1 Service Tool for Caterpillar P1STC Is Available for Caterpillar Paving Products {0785}
563C and 573C Wheel Feller Bunchers Additional Messages