521B and 522B Track Feller Bunchers Caterpillar


Swing Drive Oil Sample - Obtain

Usage:

521B F7B
The dipstick for the swing drive oil is on the swing drive at the rear base of the boom.

  1. Open the hood. Refer to Operation and Maintenance Manual, "Hood Tilting" for the procedure.


    Illustration 1g01058733
    (1) Dipstick.

  2. Remove dipstick (1).

  3. Obtain a sample of the final drive oil through the dipstick tube. Use a fluid sampling pump to obtain an oil sample from a nonpressurized oil system. Consult your Caterpillar dealer for the current part number for the fluid sampling pump.

  4. Insert dipstick (1).

  5. Close the hood.

Refer to Special Publication, SEBU6250, "S·O·S Oil Analysis" for information that pertains to obtaining a sample of the swing drive oil. Refer to Special Publication, PEHP6001, "How To Take A Good Oil Sample" for more information about obtaining a sample of the swing drive oil.

Caterpillar Information System:

521B and 522B Track Feller Bunchers Swing Drive Oil - Change
AP1000F Asphalt Paver Machine Systems Hydraulic Filter (Suction Return) - Remove and Install
541 Series 2 and 552 Series 2 Track Feller Bunchers Refrigerant Dryer - Replace
541 Series 2 and 552 Series 2 Track Feller Bunchers Hydraulic System Oil Sample - Obtain
C9.3 Engines for Caterpillar Built Machines Inlet Manifold - Remove and Install
541 Series 2 and 552 Series 2 Track Feller Bunchers Hydraulic System Oil Level (Hood Tilt) - Check
541 Series 2 and 552 Series 2 Track Feller Bunchers Hydraulic System Oil Level - Check
AP1055E Asphalt Paver Equipped with a Cat C6.6 Engine Safety Messages
541 Series 2 and 552 Series 2 Track Feller Bunchers Hydraulic System Oil Filter (Return) - Replace
541 Series 2 and 552 Series 2 Track Feller Bunchers Hydraulic System Oil Filter (Case Drain) - Replace
541 Series 2 and 552 Series 2 Track Feller Bunchers Hydraulic System Oil Filter (Pilot) - Replace
2011/05/09 New Steering Cylinder Sensor Harnesses are now Available for Certain M Series Motor Graders {1408}
PL83 Pipelayer Transmission System Oil Sample - Obtain
AP1000E and BG1000E Asphalt Pavers Machine Systems Piston Pump (Auxiliary) - Remove
AP1000E and BG1000E Asphalt Pavers Machine Systems Piston Pump (Auxiliary) - Install
PL83 Pipelayer Reference Material
NEHS1126: 370-8570 Bulk Fuel Filtration Group 200 GPM Flow Rate {0599, 0680, 0706, 0782, 1250, 1280} NEHS1126: 370-8570 Bulk Fuel Filtration Group 200 GPM Flow Rate {0599, 0680, 0706, 0782, 1250, 1280}
C13, C15, and C18 Tier 4 Final Engines Exhaust Gas Valve (NRS)
2011/05/26 New Cylinder Pack Assemblies Are Available in Sets for Certain Machines Equipped with C18 Engines {1201, 1216, 1225, 1239}
777G Off-Highway Truck Lubrication Pump Oil Level - Check
Comfort Series Seat For Caterpillar Machines Optimized Seat with Lumbar, Side Controls, and Slide Swivel
777G Off-Highway Truck Lubrication Pump Oil - Change
3516B Engine for 994F and 994H Wheel Loaders Configuration Parameters
AP1000E and BG1000E Asphalt Pavers Machine Systems Piston Motor (Propel) - Remove
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.