Wiring Harness (Open Circuit) - Test
An open is a failure of an electrical circuit that results in no flow of electrical current. An open circuit is caused by failed electrical wires or a poor connection of electrical connectors. If an electrical wire or a connection is broken, the flow of electrical current through the circuit is interrupted. A normally closed circuit will have less than 5 ohms of resistance. The following procedure explains the test for an open circuit:
ReferenceFor a complete electrical schematic, refer to Electrical System Schematic.
TEST FOR AN OPEN CIRCUIT.
- Identify the connectors and the wire numbers of the suspect circuits. Use the systems electrical schematic to identify the circuits.
- Disconnect power from the system to be tested.
- Disconnect the wiring harness at both ends of the suspect circuit.
- At one of the disconnected wiring harness connectors place a jumper wire from the contact of the suspect wire to ground.
- At the other connector of the wiring harness, use the multimeter probes to measure the resistance from the contact of the suspect wire to ground.
Expected Result: The resistance is less than 5 ohms.
OK - The resistance is less than 5 ohms. The harness circuit is correct.
Stop.
NOT OK - The resistance is greater than 5 ohms. There is an open in the machine harness.
Repair: Repair the wiring harness or replace the wiring harness.
Stop.
Caterpillar Information System:
2009/03/30 Special Instruction , "797B Off-Highway Truck Assembly Procedure" Has Been Updated {7000, 7006, 7960}
2009/03/02 Inspection and the Repair Procedure for the Hoist Tube In the Frame Assembly Is Available {7050, 7050}
2009/03/23 The Manufacturing Process for the Slip Joint Group is Updated {3253}
2009/03/09 A New Tube Updates the Water Lines Group for the High Altitude Machine Arrangement {1380}
795F AC and 795F AC XQ Off-Highway Trucks Inverter Cabinet - Check/Clean
3408E and 3412E Engines for Caterpillar Built Machines Event Codes
SystemOne Tool Reference {0729, 4150} SystemOne Tool Reference {0729, 4150}
583T Pipelayer Alternate Exit
587R Pipelayer Alternate Exit
587T Pipelayer Alternate Exit
CP44 and CS44 Vibratory Soil Compactors Tire Inflation - Check
AccuGrade® GPS v11 for CD700 Blade Pitch Sensor - Calibrate
MINEGEM Machine Control ; Guidance Products Local Area Radio Network Wiring Harness (Short Circuit) - Test
MINEGEM Machine Control ; Guidance Products Area Isolation System General Information
MINEGEM Machine Control ; Guidance Products Local Area Radio Network Using the Operator Monitor to Determine Diagnostic Codes
MINEGEM Machine Control ; Guidance Products Machine Automation System Service Tools
CD54 Vibratory Compactor Machine Systems Water Spray Pump
584 and 584HD Forwarders Operator Controls
795F AC and 795F AC XQ Off-Highway Trucks Electric Cable - Check - High Voltage Harness
3408E and 3412E Engines for Caterpillar Built Machines System Overview
2009/08/10 A New Propel Motor and A New Seal Kit Are Now Used on Certain Paving Compactors {4351, 5058}
789D, 793F, and 797F Off-Highway Truck Monitoring System MID 053 - CID 0168 - FMI 03
Surface Finishes of Cylinder Bores{7562} Surface Finishes of Cylinder Bores{7562}
Monitoring Parameters Are Not Activated Until the Engine's RPM Has Reached Low Idle{1000, 1901, 1920} Monitoring Parameters Are Not Activated Until the Engine's RPM Has Reached Low Idle{1000, 1901, 1920}