Water Spray Pump
Show/hide table
Illustration 1 | g01834473 |
Rear right view |
Type ... Positive displacement
Nominal voltage ... 12 VDC
Pressure that is required to open the contact points of the pressure switch ... 300 ± 13 kPa (44 ± 2 psi)
Pressure that is required to close the contact points of the pressure switch ... 172 ± 13 kPa (25 ± 2 psi)
Flow rate at 172 kPa (25 psi) ... 3.5 ± 0.5 L/min (0.9 ± 0.1 US gpm)
Flow rate at 0 kPa (0 psi) ... 8.3 ± 0.5 L/min (2.2 ± 0.1 US gpm)
Note: Apply 4C-4030 Thread Lock Compound to the threads of the bolts (1) .
(1) Torque for four bolts ... 6 ± 1 N·m (53 ± 9 lb in)
Caterpillar Information System:
MINEGEM Machine Control ; Guidance Products Machine Automation System Service Tools
MINEGEM Machine Control ; Guidance Products Local Area Radio Network Using the Operator Monitor to Determine Diagnostic Codes
MINEGEM Machine Control ; Guidance Products Area Isolation System General Information
MINEGEM Machine Control ; Guidance Products Local Area Radio Network Wiring Harness (Short Circuit) - Test
MINEGEM Machine Control ; Guidance Products Machine Automation System Wiring Harness (Open Circuit) - Test
2009/03/30 Special Instruction , "797B Off-Highway Truck Assembly Procedure" Has Been Updated {7000, 7006, 7960}
2009/03/02 Inspection and the Repair Procedure for the Hoist Tube In the Frame Assembly Is Available {7050, 7050}
2009/03/23 The Manufacturing Process for the Slip Joint Group is Updated {3253}
2009/03/09 A New Tube Updates the Water Lines Group for the High Altitude Machine Arrangement {1380}
795F AC and 795F AC XQ Off-Highway Trucks Inverter Cabinet - Check/Clean
3408E and 3412E Engines for Caterpillar Built Machines Event Codes
SystemOne Tool Reference {0729, 4150} SystemOne Tool Reference {0729, 4150}
584 and 584HD Forwarders Operator Controls
795F AC and 795F AC XQ Off-Highway Trucks Electric Cable - Check - High Voltage Harness
3408E and 3412E Engines for Caterpillar Built Machines System Overview
2009/08/10 A New Propel Motor and A New Seal Kit Are Now Used on Certain Paving Compactors {4351, 5058}
789D, 793F, and 797F Off-Highway Truck Monitoring System MID 053 - CID 0168 - FMI 03
Surface Finishes of Cylinder Bores{7562} Surface Finishes of Cylinder Bores{7562}
Monitoring Parameters Are Not Activated Until the Engine's RPM Has Reached Low Idle{1000, 1901, 1920} Monitoring Parameters Are Not Activated Until the Engine's RPM Has Reached Low Idle{1000, 1901, 1920}
Applying Grease to the Hoist Cylinder Bearings{5102} Applying Grease to the Hoist Cylinder Bearings{5102}
2009/03/23 Correction to Disassembly and Assembly , "Service Brake - Disassemble" {4251}
795F AC and 795F AC XQ Off-Highway Trucks Fuses, Circuit Breakers and Relays - Replace/Reset
MINEGEM Machine Control ; Guidance Products Area Isolation System Visual Inspection
MINEGEM Machine Control ; Guidance Products Area Isolation System Area Isolation System Troubleshooting