Service Tools
The following service tools should be used in order to aid in troubleshooting the MINEGEM system.
Show/hide table
Service Tools     | |
Part Number     | Part     |
    | IBM-COMPATIBLE personal computer     |
257-9140 237-5130     |
Digital Multimeter     |
7X-1710     | Multimeter Probe     |
9U-7246     | Connector Repair Kit ( Deutsch DT Type )     |
4C-3406     | Connector Repair Kit ( Deutsch Type )     |
Use a digital multimeter for measuring resistance or for measuring voltage. The 7X-1710 Multimeter Probe measures the voltage at the connectors without disconnecting the connectors. The probe cables are pushed into the back of the connector along the wire.
Use Caterpillar Electronic Technician (Cat ET) in order to observe diagnostic codes.
Note: Except for harness tests, using the 8T-0500 Continuity Tester, or the 5P-7277 Voltage Tester is not recommended for Caterpillar electrical circuits.
For instructions on servicing Deutsch connectors refer to Special Instruction, SEHS9615.
Caterpillar Information System:
MINEGEM Machine Control ; Guidance Products Local Area Radio Network Using the Operator Monitor to Determine Diagnostic Codes
MINEGEM Machine Control ; Guidance Products Area Isolation System General Information
MINEGEM Machine Control ; Guidance Products Local Area Radio Network Wiring Harness (Short Circuit) - Test
MINEGEM Machine Control ; Guidance Products Machine Automation System Wiring Harness (Open Circuit) - Test
2009/03/30 Special Instruction , "797B Off-Highway Truck Assembly Procedure" Has Been Updated {7000, 7006, 7960}
2009/03/02 Inspection and the Repair Procedure for the Hoist Tube In the Frame Assembly Is Available {7050, 7050}
2009/03/23 The Manufacturing Process for the Slip Joint Group is Updated {3253}
2009/03/09 A New Tube Updates the Water Lines Group for the High Altitude Machine Arrangement {1380}
795F AC and 795F AC XQ Off-Highway Trucks Inverter Cabinet - Check/Clean
3408E and 3412E Engines for Caterpillar Built Machines Event Codes
SystemOne Tool Reference {0729, 4150} SystemOne Tool Reference {0729, 4150}
583T Pipelayer Alternate Exit
CD54 Vibratory Compactor Machine Systems Water Spray Pump
584 and 584HD Forwarders Operator Controls
795F AC and 795F AC XQ Off-Highway Trucks Electric Cable - Check - High Voltage Harness
3408E and 3412E Engines for Caterpillar Built Machines System Overview
2009/08/10 A New Propel Motor and A New Seal Kit Are Now Used on Certain Paving Compactors {4351, 5058}
789D, 793F, and 797F Off-Highway Truck Monitoring System MID 053 - CID 0168 - FMI 03
Surface Finishes of Cylinder Bores{7562} Surface Finishes of Cylinder Bores{7562}
Monitoring Parameters Are Not Activated Until the Engine's RPM Has Reached Low Idle{1000, 1901, 1920} Monitoring Parameters Are Not Activated Until the Engine's RPM Has Reached Low Idle{1000, 1901, 1920}
Applying Grease to the Hoist Cylinder Bearings{5102} Applying Grease to the Hoist Cylinder Bearings{5102}
2009/03/23 Correction to Disassembly and Assembly , "Service Brake - Disassemble" {4251}
795F AC and 795F AC XQ Off-Highway Trucks Fuses, Circuit Breakers and Relays - Replace/Reset
MINEGEM Machine Control ; Guidance Products Area Isolation System Visual Inspection