Correction to Troubleshooting Testing and Adjusting , "Differential Backlash and Bearings - Adjust" {3258}
- Load Haul Dump:
- R1300GSeries II (S/N: RSL1-UP)
The information in Step 15 for the adjustment procedure has changed. Refer to the following information.
15. Tighten adjusting nut (4) by 70 degrees plus the increment to the nearest lock position.
Note: When you check for correct assembly and for correct adjustment, measure the rolling torque of the bevel gear group at the shaft of the pinion. For new bearings, the rolling torque should be 1.8 to 7.4 N·m (16 to 65 lb in). For used bearings, the rolling torque should be 0.9 to 3.7 N·m (8 to 33 lb in).
Caterpillar Information System:
MINEGEM Machine Control ; Guidance Products Machine Automation System Machine Preparation for Troubleshooting
2009/03/23 Correction to Disassembly and Assembly , "Differential and Bevel Gear - Install" {3256, 3258}
2009/05/04 New Fuel Lines are Now Used for the Transfer Pump {1274}
2009/03/23 Correction to Disassembly and Assembly , "Differentials and Pinion Assemblies" {3258}
793F and 797F Off-Highway Trucks Power Train Electronic Control System Diagnostic Capabilities
Work Tool (Custom) and 343-8734 Fusion Pallet Fork Specifications
CP44 and CS44 Vibratory Soil Compactors Tire Inflation Pressure Adjustment
CP44 and CS44 Vibratory Soil Compactors Tire Shipping Pressure
2010/04/22 The Tube Assembly and Mounting from the Brake and Fan Drive Pump to the Valve Has Been Improved {1374, 1386, 5057}
2009/07/06 New Fan Guard and Shroud Is Now Used. {1356}
CP44 and CS44 Vibratory Soil Compactors Operation Information
Air Conditioning and Heating R134a for All Caterpillar Machines Refrigerant Compressor
725C, 725C2, 730C, 730C2 and 730C, 730C2 EJECTOR Articulated Truck Systems Pump Drive - PTO
AccuGrade® GPS v11 for CD700 Blade Pitch Sensor - Calibrate
CP44 and CS44 Vibratory Soil Compactors Tire Inflation - Check
587T Pipelayer Alternate Exit
587R Pipelayer Alternate Exit
583T Pipelayer Alternate Exit
SystemOne Tool Reference {0729, 4150} SystemOne Tool Reference {0729, 4150}
3408E and 3412E Engines for Caterpillar Built Machines Event Codes
795F AC and 795F AC XQ Off-Highway Trucks Inverter Cabinet - Check/Clean
2009/03/09 A New Tube Updates the Water Lines Group for the High Altitude Machine Arrangement {1380}
2009/03/23 The Manufacturing Process for the Slip Joint Group is Updated {3253}
2009/03/02 Inspection and the Repair Procedure for the Hoist Tube In the Frame Assembly Is Available {7050, 7050}