- Load Haul Dump:
- R1300 (S/N: 6QW1-UP)
The information in Step 26 and Step 27 for the adjustment procedure has changed. Refer to the following information.
26. Tighten adjusting nut (4) by 70 degrees plus the increment to the nearest lock position.
Note: When you check for correct assembly and for correct adjustment, measure the rolling torque of the bevel gear group at the shaft of the pinion. For new bearings, the rolling torque should be 1.8 to 7.4 N·m (16 to 65 lb in). For used bearings, the rolling torque should be 0.9 to 3.7 N·m (8 to 33 lb in).
27. Measure the backlash between bevel gear (12) and the pinion shaft. Measure the backlash at the bevel gear heel. The backlash must be 0.30 + 0.12 − 0.10 mm (.012 + .005 − .004 inch). To measure the backlash, place a dial indicator tangent to the spline, as shown. Make sure that the yoke or the spline adapter is tight to the spline.