PM-201 Cold Planer Machine Systems Caterpillar

Removal Procedure

Start By:

1. Remove the engine enclosure (hood), if necessary. Refer to Disassembly and Assembly, "Engine Enlcosure (Hood) - Remove and Install".
2. Remove the rotor drive shaft. Refer to Disassembly and Assembly, "Drive Shaft (Rotor) - Remove and Install".
3. Remove the auxiliary pump, if necessary. Refer to Disassembly and Assembly, "Piston Pump (Auxiliary) - Remove".
4. Remove the propel pump, if necessary. Refer to Disassembly and Assembly, "Piston Pump (Propel) - Remove".

Show/hide table



Illustration 1	g01443809

1. Remove bolts (1) and cover (2) .

2. Remove bolts (3) and cover (4) .

Show/hide table



Illustration 2	g01443810

3. Drain the oil from oil tank (6) into a suitable container for storage or disposal. Refer to Operation and Maintenance Manual for the correct procedure.

4. Disconnect harness assemblies (5) .

5. Disconnect hose assemblies (7) .

Show/hide table



Illustration 3	g01443811

6. Disconnect hose assembly (8) from oil tank (6) .

Show/hide table



Illustration 4	g01443813

7. Remove the bolts, filler tube assembly (9), and gasket (10) .

Show/hide table



Illustration 5	g01443814

8. Remove bolts (12) and remove tube assembly (11) from oil tank (6) .

Show/hide table



Illustration 6	g01443815

9. Loosen clamp (14) from hose (13) .

10. Attach lifting straps and a suitable lifting device to oil tank (6). Remove bolts (15) and lower oil tank (6). The weight of oil tank (6) is approximately 122 kg (270 lb).

Installation Procedure

Show/hide table



Illustration 7	g01443815

1. Attach lifting straps and a suitable lifting device to oil tank (6). Raise oil tank (6) and install bolts (15). The weight of oil tank (6) is approximately 122 kg (270 lb).

2. Tighten clamp (14) to hose (13) .

Show/hide table



Illustration 8	g01443814

3. Install tube assembly (11) to oil tank (6) and install bolts (12) .

Show/hide table



Illustration 9	g01443813

4. Install gasket (10), filler tube assembly (9), and the bolts.

Show/hide table



Illustration 10	g01443811

5. Connect hose assembly (8) to oil tank (6) .

Show/hide table



Illustration 11	g01443810

6. Connect hose assemblies (7) .

7. Connect harness assemblies (5) .

8. Fill the oil tank with oil. Refer to Operation and Maintenance Manual for the correct procedure.

Show/hide table



Illustration 12	g01443809

9. Install cover (4) and bolts (3) .

10. Install cover (2) and bolts (1) .

End By:

1. Install the propel pump, if necessary. Refer to Disassembly and Assembly, "Piston Pump (Propel) - Install".
2. Install the auxiliary pump, if necessary. Refer to Disassembly and Assembly, "Piston Pump (Auxiliary) - Install".
3. Install the rotor drive shaft. Refer to Disassembly and Assembly, "Drive Shaft (Rotor) - Remove and Install".
4. Install the engine enclosure (hood), if necessary. Refer to Disassembly and Assembly, "Engine Enlcosure (Hood) - Remove and Install".