Removal Procedure
Show/hide table
Table 1
| Required Tools |
| Tool |
Part Number |
Part Description |
Qty |
| A |
6V-2082 |
Lifting Hook |
1 |
Show/hide table
 |
Personal injury can result from hydraulic oil pressure and hot oil. Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system. Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand. |
 |
Show/hide table
|
| NOTICE |
|---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the machine. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide"for tools and supplies to collect and contain fluids in Caterpillar machines. Dispose of all fluids according to local regulations. |
|
Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, hoses, and tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
Show/hide table
|
 |
|
| Illustration 1 | g01388530 |
- Disconnect hose assemblies (2) from gerotor motor (1) .
Show/hide table
|
 |
|
| Illustration 2 | g01388584 |
- Remove bolts (3) and cover (4) .
Show/hide table
|
 |
|
| Illustration 3 | g01388532 |
- Attach a suitable lifting device to drum support (5). Raise the machine slightly and install suitable blocks under the frame, as shown.
- Remove bolts (6), bolts (7), and drum support (5). The weight of drum support (5) is approximately 50 kg (110 lb).
Show/hide table
|
 |
|
| Illustration 4 | g01388534 |
- Attach Tooling (A) to support assembly (9). Remove bolts (8) and support assembly (9). The weight of support assembly (9) is approximately 32 kg (70 lb).
Show/hide table
|
 |
|
| Illustration 5 | g01388537 |
- Remove bolts (11) and plate (10) from final drive assembly (12) .
Show/hide table
|
 |
|
| Illustration 6 | g01388674 |
- Remove bolts (13) and gerotor motor (1) from final drive assembly (12) .
