AP655D and BG655D Asphalt Pavers Propel System Caterpillar

Propel Lever - Calibrate - Right Station

Usage:

Show/hide table

Personal injury or death can result from sudden machine movement.
Sudden movement of the machine can cause injury to persons on or near the machine.

To prevent injury or death, make sure that the area around the machine is clear of personnel and obstructions before operating the machine.

Show/hide table

Injury to personnel can result if they are not in the operator's view. Allow only essential personnel near the machine, and make sure the personnel are in the operator's view when testing, to prevent injury. Make sure checks are done in an open area.

Show/hide table

Personal injury can result from rotating and moving parts.
Stay clear of all rotating and moving parts.
Never attempt adjustments while the machine is moving or the engine is running unless otherwise specified.

The machine must be parked on a level surface and the engine stopped.

Drive the machine to a smooth, horizontal surface.
Show/hide table

Illustration 1 g01360657
Move propulsion lever (3) to the NEUTRAL position.
Rotate speed dial (2) to the MINIMUM position.
Move parking brake switch (1) to the ON position.
Show/hide table

Illustration 2 g01360659
Move screed lift switch (4) to the RAISE position. Completely lift the screed.
Show/hide table

Illustration 3 g01360660
Engage screed lock mechanism (5) on both sides of the machine.
Move screed lift switch (4) to the FLOAT position.
Show/hide table

Illustration 4 g01360662
Move throttle control switch (6) to the LOW IDLE position. Hold the switch in this position for less than 1 second.
After the engine reaches low idle, move engine start switch (7) to the OFF position.
Move engine start switch (7) to the ON position. Do not start the engine.
Show/hide table

Illustration 5 g01360664
Press home key (8).
Show/hide table

Illustration 6 g01360665
Press down key (9) until "Service" is highlighted on the display screen.
Press "OK" key (10).
Show/hide table

Illustration 7 g01360668
Press down key (9) until "Calibrations" is highlighted on the display screen.
Press "OK" key (10).
Show/hide table

Illustration 8 g01360670
Press down key (9) until "Rt Station Propel Lvr" is highlighted on the display screen.
Press "OK" key (10).
Press "OK" key (10) in order to begin the calibration.
Show/hide table

Illustration 9 g01360671

Show/hide table

Illustration 10 g01360672
Move operator station select switch (11) to the RIGHT position.
Press "OK" key (10).
Show/hide table

Illustration 11 g01360677

Show/hide table

Illustration 12 g01360678
Move propulsion lever (12) on the right instrument panel to the NEUTRAL position.
Press "OK" key (10).
Show/hide table

Illustration 13 g01360682
The display should now read "CALIBRATION COMPLETE". Push back key (13) in order to return to calibration screen.
Push home key (8) in order to exit the calibration screen.
Move the operator station select switch to the LEFT position.
Move engine start switch (9) to the OFF position.