AP655D and BG655D Asphalt Pavers Propel System Caterpillar

Propel Lever - Calibrate - Left Station

Usage:

Show/hide table

Personal injury or death can result from sudden machine movement.
Sudden movement of the machine can cause injury to persons on or near the machine.

To prevent injury or death, make sure that the area around the machine is clear of personnel and obstructions before operating the machine.

Show/hide table

Injury to personnel can result if they are not in the operator's view. Allow only essential personnel near the machine, and make sure the personnel are in the operator's view when testing, to prevent injury. Make sure checks are done in an open area.

Show/hide table

Personal injury can result from rotating and moving parts.
Stay clear of all rotating and moving parts.
Never attempt adjustments while the machine is moving or the engine is running unless otherwise specified.

The machine must be parked on a level surface and the engine stopped.

Drive the machine to a smooth, horizontal surface.
Show/hide table

Illustration 1 g01360589
Move propulsion lever (3) to the NEUTRAL position.
Rotate speed dial (2) to the MINIMUM position.
Move parking brake switch (1) to the ON position.
Show/hide table

Illustration 2 g01360596
Move screed lift switch (4) to the RAISE position. Completely lift the screed.
Show/hide table

Illustration 3 g01360600
Engage screed lock mechanism (5) on both sides of the machine.
Move screed lift switch (4) to the FLOAT position.
Note: The screed lift switch on the inactive instrument panel must also be in the FLOAT position in order to lower the screed.
Show/hide table

Illustration 4 g01360601
Move throttle control switch (6) to the LOW IDLE position. Hold the switch in this position for less than 1 second.
After the engine reaches low idle, move engine start switch (7) to the OFF position.
Move engine start switch (7) to the ON position. Do not start the engine.
Show/hide table

Illustration 5 g01360604
Press home key (8).
Show/hide table

Illustration 6 g01360626
Press down key (9) until "Service" is highlighted on the display screen.
Press "OK" key (10).
Show/hide table

Illustration 7 g01360637
Press down key (9) until "Calibrations" is highlighted on the display screen.
Press "OK" key (10).
Show/hide table

Illustration 8 g01360639
Press down key (9) until "Lt Station Propel Lvr" is highlighted on the display screen.
Press "OK" key (10).
Press "OK" key (10) in order to begin the calibration.
Show/hide table

Illustration 9 g01360640

Show/hide table

Illustration 10 g01360643
Move operator station select switch (11) to the LEFT position.
Press "OK" key (10).
Show/hide table

Illustration 11 g01360645
Move propulsion lever (3) on the left instrument panel to the NEUTRAL position.
Press "OK" key (10).
Show/hide table

Illustration 12 g01360646
The display should now read "CALIBRATION COMPLETE". Push back key (12) in order to return to the calibration screen.
Push home key (8) in order to exit the calibration screen.
Move engine start switch (7) to the OFF position.