The following information is a guide to reading the tables on the back of the Electrical System Schematic.
- The "Component Location" table uses white circles to mark the locations in the profile of the vehicle and in the area views. Alphabetical letters in the "Machine Location" column indicate a general area of the vehicle. Refer to the corresponding footnote at the end of the table for a description of the location.
- The "Harness Connector Location" table uses white circles to mark the locations in the general view and in the area views. Alphabetical letters in the "Machine Location" column indicate a general area of the vehicle. Refer to the corresponding footnote at the end of the table for a description of the location.
Illustration 1 | g01340294 |
(1) Left side Hydrostatic Pump (2) Right side Hydrostatic Pump (3) Hydrostatic Motors (4) Power Train Return Manifold |
Parking Brake Switch
The switch is located on the switch panel that is located to the right of the seat.
Transmission Pilot Supply Solenoid
The pilot solenoid is located on the manifold (4) next to the parking brake solenoid.
Brake Pedal and Deceleration Pedal (Sensor)
Illustration 2 | g01340329 |
The sensor is a part of the pedal housing. Remove the access panel (A) in order to access the sensor.
Brake Pedal and Deceleration Pedal (Switch)
Illustration 3 | g01340329 |
The switch is a part of the pedal housing. Remove the access panel (A) in order to access the switch.
Parking Brake Solenoid
The pilot solenoid is located on the manifold (4) .
Steering Sensors
Illustration 4 | g01338124 |
The sensors for the joystick steering are located in the base of the joystick. The entire base must be replaced in the event of a sensor failure.
Acceleration and Deceleration (Thumb Switch)
Illustration 5 | g01339854 |
The thumb switch is located on the joystick for the transmission.
Recall Speed
Illustration 6 | g01339851 |
The switch is the yellow button that is located on the joystick for the transmission.
Horn Switch
Illustration 7 | g01339852 |
The horn switch is the black button that is located on the joystick for the transmission.
Pump Solenoids
Illustration 8 | g01340306 |
(5) Right Hydrostatic Pump (6) Reverse Solenoid (7) Left Hydrostatic Pump (8) Reverse Solenoid (9) Forward Solenoid (10) Forward Solenoid |
The forward and the reverse solenoids for the left side are located on the left pump. The forward and the reverse solenoids for the right side are located on the right pump. The solenoids allow oil to flow to the left side motor and the right side motor.
Left Track Motor
Illustration 9 | g01340653 |
The motor can be accessed by removing the panel that is located on the back of the machine. (11) Left Track Speed Sensor (12) Travel Pressure Sensor (13) Left Motor Solenoid |
The left track speed sensor is located on the back of the left motor.
The travel pressure sensor is located on the back of the left motor.
The left motor solenoid is located on the back of the left motor.
Right Track Motor
Illustration 10 | g01340656 |
The motor can be accessed by removing the panel that is located on the back of the machine. (14) Right Motor Solenoid (15) Right Track Speed Sensor |
The sensor is located on the right motor on the right side of the machine.
Backup Alarm
The backup alarm is mounted on the rear of the machine.
Illustration 11 | g01228286 |
Backup alarm - The alarm will sound when the lever for the steering and transmission control is in the REVERSE position. The alarm is used to alert people behind the machine that the machine is backing up.