Removal Procedure
Show/hide table
|
| NOTICE |
|---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
|
Note: Put identification marks on all hoses, on all hose assemblies, on all wires, and on all tube assemblies for installation purposes. Plug all hose assemblies and all tube assemblies. This helps to prevent fluid loss, and this helps to keep contaminants from entering the system.
- Drain the coolant from the cooling system into a suitable container for storage or disposal. Refer to Operation and Maintenance Manual, "Cooling System Coolant (ELC) - Change".
Show/hide table
|
 |
|
| Illustration 1 | g01157783 |
- Loosen clamps (1) and (4). Remove hose (2) and elbow (3) .
Show/hide table
|
 |
|
| Illustration 2 | g01157785 |
- Remove bolts (7). Reposition clip (6) and remove guard assembly (5) .
Show/hide table
|
 |
|
| Illustration 3 | g01157788 |
- Disconnect hose assembly (9) and reposition hose assembly (9). Remove tube assembly (8) .
Show/hide table
|
 |
|
| Illustration 4 | g01157800 |
- Disconnect clip (10). Remove plug (12) and drain the coolant into a suitable container for storage or disposal. Disconnect hose (11) .
Show/hide table
|
 |
|
| Illustration 5 | g01157803 |
- Loosen clamps (14) and reposition hose (13) .
Show/hide table
|
 |
|
| Illustration 6 | g01157806 |
- Remove bolts (15) .
Show/hide table
|
 |
|
| Illustration 7 | g01157807 |
- Remove bolts (19). Remove bracket (16). Remove bolts (17) and engine oil cooler (18) .
