 | |
| Illustration 1 | g01162103 |
(4) Horn (5) Switch for the Reversible Engine Fan (6) 12 V Power Receptacle (8) Joystick Controls (10) Control for the Saw Blade (11) Engine Start Switch (12) Throttle (13) Work Light Switch Forward (14) Work Light Switch Rear (15) Travel Speed Control Switch (16) Auto Accumulator Arms Control (17) Travel Alarm Cancel Switch (18) Air Conditioning and Heating Controls (19) Cigar Lighter (21) Hood Control Switch (28) Saw Blade On Light (29) Saw Blade Off Light (30) Switch for Maintenance Lights in the Engine Compartment | |
The common cab arrangement is shown in illustration 1. Refer to the serial numbers that are listed above. Refer to the reference number above for operation of each component.
 | |
| Illustration 2 | g01162641 |
| Locked - Move the travel levers/pedals and move the joysticks to the HOLD (center) position. Move the hydraulic control lever (A) backward to the LOCKED position. This makes all of the factory installed hydraulic controls inoperable. |
Note: Make sure that the hydraulic control lever is in the LOCKED position before attempting to start the engine. If the lever is in the UNLOCKED position, the engine start switch will not function.
 | |
| Illustration 3 | g01163425 |
| Unlocked - Move the hydraulic control lever (A) forward to the UNLOCKED position. This makes all of the factory installed hydraulic controls operable. When the lever (B) is in the forward position, the hydraulics are active. |
Note: Do not leave the operator seat while the hydraulics are unlocked.