Removal Procedure
Required Tools     | |||
---|---|---|---|
Tool     | Part Number     | Part Description     | Qty     |
ZZ     | 6V-9509     | Face Seal Plug (13/16 - 16 THD)     | 4     |
6V-9830 | Cap Assembly (13/16 - 16 THD)     | 4     |
Start By:
- Remove the steering column. Refer to Disassembly and Assembly, "Steering Column - Remove and Install".
Note: SERVICE DATA: TOOLING (ZZ) WILL NOT BE IDENTIFIED IN PHOTOGRAPHS IN THE REMOVAL OR THE INSTALLATION. THIS TOOLING IS SHOWN IN ORDER TO ASSIST THE EXPERIENCED SERVICEMAN.
Hot oil and components can cause personal injury. Do not allow hot oil or components to contact the skin. Be sure that the engine and components are cool enough to touch with your bare hand prior to performing any service work. |
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
- Disconnect hose assemblies (2) from metering pump (1) and remove metering pump (1) from the machine.
Illustration 1 | g01119085 |
Installation Procedure
- Install metering pump (1) and connect hose assemblies (2) to metering pump (1) .
Illustration 2 | g01119085 |
End By: Install the steering column. Refer to Disassembly and Assembly, "Steering Column - Remove and Install".