554, 564 and 574B Forwarders Caterpillar


Oil Filter (Power Train Charging System) - Replace

Usage:

564 KBN

  • Open the hood. Tilt the cab.

    Reference: Refer to Operation and Maintenance Manual, "Cab Tilting" for the correct procedure.




      Illustration 1g00992915

      The oil filter for the 564 and 574B Forwarders is shown.

    1. Use a strap type wrench to remove the oil filter. Dispose of the used oil filter properly.

      Note: The oil filter for the 564 and 574B Forwarders is on the left side. The oil filter for the 554 Forwarder is on the right side.

    1. Remove all of the used gasket from the filter mounting base.



      Illustration 2g00101318

    1. Apply clean hydraulic oil to the gasket of the new oil filter.

    1. Install the new filter by hand. When the gasket contacts the filter mounting base, tighten the filter by an additional 3/4 turn.

    1. Operate the machine for a few minutes. Check for leaks. Check the oil level of the hydraulic oil tank.

      Reference: Refer to Operation and Maintenance Manual, "Hydraulic Oil Level - Check" for the correct procedure.

    1. Lower the cab and close the hood.
  • Caterpillar Information System:

    2003/09/08 New Software for Off-Highway Trucks Is Now Available {7620}
    IT28G Integrated Toolcarrier and 924G, 924GZ and 928G Wheel Loaders Engine Supplement Hydraulic and Transmission Oil Cooler - Remove
    554, 564 and 574B Forwarders Hydraulic System Oil Level - Check
    TK370 Wheel Feller Buncher, TK380 Wheel Feller Buncher, TK371 Industrial Tractor and TK381 Industrial Tractor Machine Systems Pilot Oil Accumulator (Dead Engine Lower) - Test and Charge
    2003/06/09 A New Body Down or Up Switch Is Now Used {7258, 7332}
    Upgrade Instructions For The Firmware of the CD550 Display And The MS840 GPS Receiver{7620} Upgrade Instructions For The Firmware of the CD550 Display And The MS840 GPS Receiver{7620}
    TK370 Wheel Feller Buncher, TK380 Wheel Feller Buncher, TK371 Industrial Tractor and TK381 Industrial Tractor Machine Systems Hydraulic System Air - Purge
    2003/04/14 There is New Information on the Oil Grade Plug {1000, 1348}
    2004/04/19 A Special Instruction, REHS1622 , "Installation and Operation of the Belt Recoil Alarm for the Mobil-Trac System" is Available for Use With the New Recoil Alarm Kit {4198, 7431}
    TK370 Wheel Feller Buncher, TK380 Wheel Feller Buncher, TK371 Industrial Tractor and TK381 Industrial Tractor Machine Systems System Pressure - Release
    TK370 Wheel Feller Buncher, TK380 Wheel Feller Buncher, TK371 Industrial Tractor and TK381 Industrial Tractor Machine Systems Visual Inspection
    Bench Test Procedure for a 928G Wheel Loader andIT28G Integrated Toolcarrier Transmission with a Flexible Coupling Drive{3030, 3066, 3073} Bench Test Procedure for a 928G Wheel Loader andIT28G Integrated Toolcarrier Transmission with a Flexible Coupling Drive{3030, 3066, 3073}
    IT28G Integrated Toolcarrier and 924G, 924GZ and 928G Wheel Loaders Engine Supplement Hydraulic and Transmission Oil Cooler - Install
    584 and 584HD Forwarders Window Wiper - Inspect/Replace
    Bench Test Procedure for a 950H, 962H, 966G, 966G Series 2, 966H, 972G, 972G Series 2, and 972H Wheel Loader Transmission and a R1600H Load Haul Dump {3030, 3066, 3073, 3101} Bench Test Procedure for a 950H, 962H, 966G, 966G Series 2, 966H, 972G, 972G Series 2, and 972H Wheel Loader Transmission and a R1600H Load Haul Dump {3030, 3066, 3073, 3101}
    CP-533E and CS-533E Vibratory Soil Compactors Propel System Axle
    TH350B, TH355B, TH360B and TH460B Telehandlers Circuit Breakers - Test
    CP-533E and CS-533E Vibratory Soil Compactors Tire Inflation Pressure Adjustment
    TK370 Wheel Feller Buncher, TK380 Wheel Feller Buncher, TK371 Industrial Tractor and TK381 Industrial Tractor Machine Systems Piston Pump (Implement) Standby Pressure - Test and Adjust
    TK370 Wheel Feller Buncher, TK380 Wheel Feller Buncher, TK371 Industrial Tractor and TK381 Industrial Tractor Machine Systems Piston Pump (Implement) High Pressure Cutoff - Test and Adjust
    TK370 Wheel Feller Buncher, TK380 Wheel Feller Buncher, TK371 Industrial Tractor and TK381 Industrial Tractor Machine Systems Pilot System Pressure - Test and Adjust
    TK370 Wheel Feller Buncher, TK380 Wheel Feller Buncher, TK371 Industrial Tractor and TK381 Industrial Tractor Machine Systems Steering Cylinder Pressure - Test and Adjust
    TK370 Wheel Feller Buncher, TK380 Wheel Feller Buncher, TK371 Industrial Tractor and TK381 Industrial Tractor Machine Systems Lift Cylinder - Isolation and Drift Check
    CP-533E and CS-533E Vibratory Soil Compactors Propel System Drum Drive Group
    Back to top
    The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
    CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.