Speed Sensor - Replace
Show/hide table
Illustration 1 | g00667337 |
Installation of the speed sensor (1) Speed Sensor (2) Locknut (3) Magnetic Core (4) Gear (5) Flywheel Housing |
Prior to replacement of the sensor, ensure that the sensor has failed. Always check that the power is available to the sensor. Measure the voltage between the contacts of the sensor. Check for metal shavings on the magnetic tip or the gear teeth.
Perform the following procedure in order to replace the speed sensor.
- Turn the key start switch and the disconnect switch to the OFF position.
- Slowly tighten speed sensor (1) into flywheel housing (5) until magnetic core (3) contacts gear (4) .
- Turn speed sensor (1) counterclockwise. The turn should be approximately 3/4 of a rotation.
- Tighten locknut (2) to a torque of 25 N·m (18.4 lb ft).
- Verify that the sensor corrects the problem.
Caterpillar Information System:
533 and 543 Wheel Feller Bunchers Power Train Transmission Gearbox - Install
570B and 580B Wheel Harvesters Machine Systems Front Frame to Rear Frame - Connect
2003/08/01 New Flywheels Are Used {1156}
770 and 772 Off-Highway Truck Chassis Electronic Control System Speed Sensor - Adjust
2002/11/01 New Software Helps Eliminate Erroneous Logging Of Diagnostic Codes {7620}
2002/11/18 The New Special Instruction, REHS1467 , "Instructions for the Relocation of the Front Engine Oil Filters on the 797 Off-Highway Truck" Is Available {1308}
CB-534D, CB-534D XW and CB-564D Paving Compactors Machine Systems Machine Preparation for Testing and Adjusting
IQAN<COMP-BREAK TAGNAME=cp850>©<COMP-RESUME> Monitoring ; Control System Operation State (B-Series Forwarder)
CB-534D, CB-534D XW and CB-564D Vibratory Asphalt Compactors Vibratory System Compactor Drum
CB-534D, CB-534D XW and CB-564D Paving Compactors Machine Systems Spray Nozzle - Adjust
HF181, HF201, HF201B, HF202, HF221 and HF222 Felling Heads Disc Saw - Clean/Inspect/Replace
CP-563E, CP-573E, CS-563E, CS-573E and CS-583E Vibratory Soil Compactors Propel System Propel System
533 and 543 Wheel Feller Bunchers Engine Supplement Turbocharger - Remove and Install
3054E Industrial Engine Lifter Group - Remove and Install
992G Wheel Loader Electrohydraulic System Electronic Control Module (ECM) - Replace
2003/07/21 A New Flywheel Is Available {1156}
2002/12/01 The Contents Of The Service Manuals For All Commercial Engines Is Available On The Caterpillar Intranet {1000}
3054E Industrial Engine Engine Oil Pump
725 and 730 Articulated Trucks Operator Controls
R1300G Load Haul Dump Power Train Differential
797 Off-Highway Truck Fan Drive Hydraulic System Worksheets
2003/02/17 Correction to Service Magazine , "New Water Pumps for Machines with 3500 Engines" {1361, 1389}
725 and 730 Articulated Trucks Refrigerant Dryer - Replace
2003/02/10 Use the Correct Accessory Drive Shaft with the Cage Assembly {1207}