Usage:
TH62 (3LN, 4TM) TH63 (3NN, 5WM) TH82 (3JN, 3KN) TH83 (3RN) TH103 (3PN) Telehandlers
Machines operating in dirty, wet environments will benefit from the greater overall width of the fender and increased length at the rear of the fender. The kits may be purchased as separate parts at the present time. Use Chart 1 and Chart 2 to identify the Required kit part number, then order the parts listed in the appropriate chart.
410 mm (16.1 in) Fenders
151-6879 Fender Kit
TH62 Telehandlers
Illustration 1.
151-6879 Kit-Fender. See Chart 3.
410 mm (16.1 in) Fenders
150-8315 Fender Kit
TH63, TH82, TH83, TH103 Telehandlers
Illustration 2.
150-8315 Fender Kit for TH63, TH82, TH83, TH103 Telehandlers. See Chart 4.
490 mm (19.3 in) Fenders
151-6880 Fender Kit
TH62 Telehandlers
Illustration 3.
151-6880 Fender Kit for TH62 Telehandler See Chart 5.
490 mm (19.3 in) Fenders
150-8316 Fender Kit
TH82 Telehandlers
Illustration 4.
150-8316 Fender Kit for TH83 Telehandlers. Tube supports are not required for this kit. See Chart 6.
Installation Procedure
Illustration 5.
Do not remove bolts which hold brackets (48) in place.
NOTICE |
---|
Do not remove the bolts holding the bracket to the rear axle. This could affect the pre-load on the steering bearings resulting in premature failure of the bearings. See Illustration 5.
|
1. When it is necessary to remove the fenders and support tubes, remove bolts (49) from the tube supports from the brackets bolted to the rear axle. If the support tubes do not require removal, remove bolts (50).
2. Assemble the fenders following the dimensions given in the appropriate location Chart 7 and Chart 8 are reference dimensions.
Illustration 6.
See Chart 7 and Chart 8.