1979/11/26 Caterpillar


Batteries Can Be Damaged If Too Much Vacuum Is Used During Electrolyte Fill{1401}

Usage:


At times, vacuum equipment is used to fill batteries with electrolyte. If too much vacuum is used, the walls between the cells can crack. The maximum vacuum that can be used without possible damage to the battery is 4 inches of mercury (Hg) or approximately 2 psi (14 kPa).

All dealers whose service departments have this vacuum equipment must check to make sure the vacuum is limited to the correct amount.

Caterpillar Information System:

1979/11/26 More Potting Material Now Used In 6N5906 Electric Service Meter{7480}
1979/11/12 Repair Of Damaged Or Worn Balancer Shaft Bores{1201,0663,1220}
1979/11/12 Puller Studs Of Same Size Can Have Different Work Capacities{0621}
1979/11/05 Wider Connecting Rods Have More Bearing Area{1214,1218}
1979/11/05 Support Plates Must Be Used To Install Earlier Marine Transmissions{3300}
1979/11/05 Two Plug Assemblies (Booster Cables) Are Available To Start Machines{1401,1453}
1979/11/05 Correct Installation Of Track Shoe Nuts{4170,4179}
1979/10/29 Improved Seal Now Used In Seawater Pump {1371}
1979/10/29 7N9843 Fuel Injection Valve Nozzle Assembly Now Used In Truck Engines {1254}
1979/10/29 New Repair Kit Is Available For Service Of Hydraulic Jack {0642}
1979/10/29 Use The 6V2034 Micrometer Adapter To Measure Lip Thickness Of Engine Valves {0653,1105}
1979/10/29 The FT1486 Chain Assembly Can Be Used For Emergency Repair Of Front Power Takeoff Clutches {3055}
1979/11/26 New Cylinder Block Has More Material Around Liner Seat Area{1201}
1979/11/26 Former Oil Pump Group Is Now Used Again{1304}
1979/11/26 Fabricated Tester For Regulator-Exciter Control Assemblies Used On SR-4 And SRCR Generators{0652,4451,4452,4454,4467}
1979/12/10 Improved 6V2012 Micrometer Depth Gauge Set Has Increased Range To Permit Deeper Measurement{0653,5070}
1979/12/10 Improvements Made To Fuel Injection Pump And Governor Group{1253,1281}
1979/12/10 New Cylinder Heads Are More Rigid And Stronger{1100}
1979/12/17 Fuel Sulfur-Your Diesel's Silent Enemy{0375,1280}
1979/12/17 General Information -- Diesel Fuels In Cold Temperature Operation{1280}
1979/12/24 Crankcase Capacity Increased; New Dimensions For Marks On Oil Level Gauge{1318,1302}
1979/12/24 Track-Excited Vibration{4121}
1979/12/24 Too Much Clearance For Exhaust Valves Can Cause Wear To The Camshaft Lobes And Valve Lifters{1105,1210,1209}
1979/12/24 New Linkage Kits With Improved Parts Are Available For Repair Of Front Power Takeoff Clutches{3055,3059}
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.