R1300G Series II Load Haul Dump Caterpillar


Fuel System Secondary Filter - Replace

Usage:

R1300G II RSL

------ WARNING! ------

发动机运转时,不要松开任何高压燃油管。燃油管路中高压回引起人身伤亡。在对发动机燃油管路进行任何保养或修理前,发动机停止后等待 60 秒钟,允许排放压力。


------ WARNING! ------

如果喷溅燃油点火,会造成人身伤亡。 泄漏或溅溢到热表面或电气部件上的燃油会引起失火。

为防止可能的伤害,当更换燃油滤清器或油水分离器滤芯时,要将蓄电池断路开关转到断开位置。 应立即将溅溢的燃油清除干净。



注意

在检验、保养、测试、调整及维修产品时,务必留心,确保液体盛装在容器中。 在打开任何腔室或拆解任何储有液体的部件之前,要准备好用合适的容器收集液体。

有关适合收集和盛接卡特彼勒产品上液体的工具及用品,参考专门出版物, NENG2500, "卡特彼勒工具和修理车间设备指南"。

按照当地法规和指令处置所有液体。



注意

安装燃油滤清器之前不要在其中注入燃油。 否则燃油不会被过滤并可能受污染。 污染的燃油会加速燃油系统部件的磨损。 起动发动机之前应向燃油系统充注油。





图 1g01138548

  1. 用带式扳手拆卸燃油滤清器滤芯。 废弃用过的滤清器。

  1. 清洁滤清器壳体基座。 确保将所有旧的密封件已去除。

  1. 在新滤清器滤芯的密封表面上涂上清洁的柴油。

  1. 用手安装新滤清器。 拧紧滤清器滤芯,直到密封表面接触到滤清器底座。 滤清器滤芯再拧紧3/4 圈。

    注: 每个滤清器上有旋转标记,间隔90度(1/4圈)。 在紧固滤清器时,用这些标记作参考。

  1. 向燃油系统充油。

    参考关于被维修机器的燃油系统充注的详细资料,参阅操作和保养手册, "燃油系统 - 充油"。

  1. 起动发动机,并检查滤清器有无泄漏。 进行所有必要的修理。

Caterpillar Information System:

R1300G Series II Load Haul Dump Fuel System Primary Filter (Water Separator) - Replace
824H Wheel Dozer, 825H Soil Compactor and 826H Landfill Compactor Electrohydraulic System Hydraulic Fan System
824H Wheel Dozer, 825H Soil Compactor and 826H Landfill Compactor Electrohydraulic System Pilot Pressure to the Main Control Valve - Check
C9 Industrial Engines Plate Locations and Film Locations
RM-300 Reclaimer Mixer Machine Systems Air Cleaner
CB-634D Vibratory Compactor Vibratory System Piston Pump Neutral - Test and Adjust
824H Wheel Dozer, 825H Soil Compactor and 826H Landfill Compactor Electrohydraulic System Relief Valve (Main) - Test and Adjust
735 and 740 Articulated Trucks Crankshaft Vibration Damper - Inspect
824H Wheel Dozer, 825H Soil Compactor and 826H Landfill Compactor Electrohydraulic System Hydraulic Fan Speed - Test and Adjust
3508B Engine for Caterpillar Built Machines Flywheel Housing
834H Wheel Dozer and 836H Landfill Compactor Steering System Piston Pump (Steering)
CB-634D Vibratory Compactor Vibratory System Relief Valve (Pressure Override) - Test and Adjust
824H Wheel Dozer, 825H Soil Compactor and 826H Landfill Compactor Electrohydraulic System Torque Converter Stall and Implement Pump Double Stall - Test
735 and 740 Articulated Trucks Engine Compression Brake Valve Lash - Check
834H Wheel Dozer and 836H Landfill Compactor Electrohydraulic System MID 082 - CID 0168 - FMI 01
735 and 740 Articulated Trucks Engine Crankcase Breather - Clean
R1300G Series II Load Haul Dump Fuel Tank Cap and Strainer - Clean
824H Wheel Dozer, 825H Soil Compactor and 826H Landfill Compactor Electrohydraulic System Pump Performance (Implement) - Test
R1300G Series II Load Haul Dump Fuel Tank Water and Sediment - Drain
R1300G Series II Load Haul Dump Fuses - Replace
307D, 311D, 312D, 313D, 315D, 318D, 319D, 320D, 323D, 324D, 325D, 326D, 328D, 329D, 330D, 336D, 340D, 345D, 349D, 374D, 390D and M325D Excavators Air Conditioning and Heating Pressure Switch (Refrigerant Pressure Cutoff)
824H Wheel Dozer, 825H Soil Compactor and 826H Landfill Compactor Electrohydraulic System Piston Motor (Hydraulic Fan)
264-9894 Control Gp-Parking Brake (Automatic) Custom Product Support Literature for the R2900G <B>S/N:</B>GLK1-UP Load Haul Dump{1408, 4250} 264-9894 Control Gp-Parking Brake (Automatic) Custom Product Support Literature for the R2900G <B>S/N:</B>GLK1-UP Load Haul Dump{1408, 4250}
AD45B Underground Articulated Truck Hydraulic System Solenoid Valve (Implement and Steering)
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.