Camshaft Bearings - Remove
Show/hide table
| 所需工具 | |||
| 工具 | 零件号 | 零件描述 | 数量 |
| A | 6V-4077 | 凸轮轴轴承工具 | 1 |
| B | 8S-2241 | 凸轮轴轴承工具总成 | 1 |
| C | 5P-5247 | 液压拉拔器 | 1 |
| D | 8H-0684 | 棘轮扳手 | 1 |
开始:
- 拆卸凸轮轴。 请参考拆解和组装, "凸轮轴 - 拆卸"。
Show/hide table
| 注意 |
|---|
|
保持所有零件清洁无杂质。 杂质会造成快速磨损並縮短部件使用寿命。 |
- 采用以下步骤安装工具 (A)。
- 在凸轮轴轴承内安装导杆总成
- 将垫板就位并确保轴承位于两个零件之间。
- 安装将工具 (A) 固定在一起的螺栓。
- 使用延长板获得工具 (A) 的正确长度。
- 在螺栓和飞轮壳体或前壳体上安装拉拔器板。
注: 拆卸飞轮壳体和前壳体时可用工具 (B) 来拆卸凸轮轴轴承。
Show/hide table
图 2 g00914512 典型实例 - 在工具 (A) 上安装工具 (C)。 从缸体上拔出轴承。
注: 如有必要，用工具 (D) 代替工具 (C)。
Show/hide table
| |
| 图 1 | g00914509 |
|
典型实例 | |
Caterpillar Information System:
G3520C and G3520E Generator Set Engines Cylinder Liner - Install
UPS 250, UPS 300, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supply Flywheel Telemetry - Calibrate
3044C Industrial Engine and Engines for Caterpillar Built Machines Engine Oil Bypass Valve - Remove and Install
G3500 Engines MID 018 - CID 0552 - FMI 11 Engine Speed present during an O2 calibration
G3500 Engines MID 018 - CID 0551 - FMI 01 Oxygen Sensor not connected to buffer
2003/06/01 Improved Radiator for the Generator Set Engine {1353}
G3520C and G3520E Generator Set Engines Piston and Connecting Rods - Install
G3520C and G3520E Generator Set Engines Piston and Connecting Rods - Remove
G3304 and G3306 Engines Crankshaft - Install
3500 Engines Fuel Filter Housing - Install
3500 Engines Fuel Filter Housing - Remove
G3304 and G3306 Engines Crankshaft - Remove
Replacing the Convection Jacket Water Heaters with a Recirculating Jacket Water Heater on 3500 Engines{1383} Replacing the Convection Jacket Water Heaters with a Recirculating Jacket Water Heater on 3500 Engines{1383}
3508C, 3512C and 3516C Marine Engines Camshaft Bearings - Install
C3.3 Industrial Engine Engine - Clean
2003/07/01 An Improved Spin-On Oil Filter Is Now Available {1306, 1308}
Installation of the 249-2439 Seal {1371} Installation of the 249-2439 Seal {1371}
C7 Engines for Combat and Tactical Vehicles Cruise Control Parameters
C7 Engines for Combat and Tactical Vehicles Smart Idle Parameters
C7 Engines for Combat and Tactical Vehicles Timer Parameters
UPS 250, UPS 300, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supply Vibration Sensors Zeroes - Calibrate
3406C Marine Auxiliary Generator Set Safety Messages
C7 Engines for Combat and Tactical Vehicles 0110-11 Very High Coolant Temperature (61)
C7 Engines for Combat and Tactical Vehicles 0100-11 Very Low Oil Pressure (46)