Engine Oil Bypass Valve - Remove and Install
Removal Procedure
Start By:
- Remove the engine oil pan. Refer to Disassembly and Assembly, "Engine Oil Pan - Remove and Install".
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Remove engine oil bypass valve (1) and gasket (2) .
Note: Check the valve and the valve seat for an abnormal contact pattern. Inspect the spring for weakness or damage. Replace the engine oil bypass valve, if necessary.
Show/hide table
Illustration 1 | g01034580 |
Installation Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Install engine oil bypass valve (1) and gasket (2) .
Show/hide table
Illustration 2 | g01034580 |
- Tighten the cap of engine oil bypass valve (1) to a torque of 64 to 74 N·m (47 to 55 lb ft).
End By: Install the engine oil pan. Refer to Disassembly and Assembly, "Engine Oil Pan - Remove and Install".
Caterpillar Information System:
G3500 Engines MID 018 - CID 0552 - FMI 11 Engine Speed present during an O2 calibration
G3500 Engines MID 018 - CID 0551 - FMI 01 Oxygen Sensor not connected to buffer
2003/06/01 Improved Radiator for the Generator Set Engine {1353}
G3520C and G3520E Generator Set Engines Piston and Connecting Rods - Install
G3520C and G3520E Generator Set Engines Piston and Connecting Rods - Remove
G3304 and G3306 Engines Crankshaft - Install
3500 Engines Fuel Filter Housing - Install
3500 Engines Fuel Filter Housing - Remove
G3304 and G3306 Engines Crankshaft - Remove
3406C Marine Auxiliary Generator Set Plate Locations and Film Locations
G3304 and G3306 Engines Camshaft Bearings - Install
G3304 and G3306 Engines Camshaft Bearings - Remove
UPS 250, UPS 300, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supply Flywheel Telemetry - Calibrate
G3520C and G3520E Generator Set Engines Cylinder Liner - Install
3508C, 3512C and 3516C Marine Engines Camshaft Bearings - Remove
Replacing the Convection Jacket Water Heaters with a Recirculating Jacket Water Heater on 3500 Engines{1383} Replacing the Convection Jacket Water Heaters with a Recirculating Jacket Water Heater on 3500 Engines{1383}
3508C, 3512C and 3516C Marine Engines Camshaft Bearings - Install
C3.3 Industrial Engine Engine - Clean
2003/07/01 An Improved Spin-On Oil Filter Is Now Available {1306, 1308}
Installation of the 249-2439 Seal {1371} Installation of the 249-2439 Seal {1371}
C7 Engines for Combat and Tactical Vehicles Cruise Control Parameters
C7 Engines for Combat and Tactical Vehicles Smart Idle Parameters
C7 Engines for Combat and Tactical Vehicles Timer Parameters
UPS 250, UPS 300, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supply Vibration Sensors Zeroes - Calibrate