Rocker Shaft and Pushrod - Remove
Removal Procedure
Start By:
- Remove the valve mechanism cover. Refer to Disassembly and Assembly, "Valve Mechanism Cover - Remove and Install".
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
- Put identification marks on each rocker arm in order to identify the proper location in the engine for installation.
- Remove bolt (1) and clip (2). Loosen nut (4) .
Show/hide table
Illustration 1 | g00995386 |
Show/hide table
Illustration 2 | g00999153 |
- Remove bolts (5). Remove jumper tube (3) .
- Loosen all rocker arm adjustment screws (6) in order to release the tension on the rocker shaft.
Show/hide table
Illustration 3 | g00999165 |
- Remove bolts (7), support bracket (8), and rocker shaft (9) .
- Repeat Step 1 through Step 5 in order to remove the other rocker shafts.
- Put identification marks on each pushrod in order to identify the proper location in the engine for installation.
- Remove the pushrods from the engine.
Caterpillar Information System:
G3304 and G3306 Engines Auxiliary Water Pump - Assemble
3054E Industrial Engine Fuel Injection Pump - Install
G3500B Engines Junction Box
3456 Generator Sets Voltage Regulators
TK711, TK721, TK722 and TK732 Track Feller Bunchers Oil Filter - Inspect
C15 and C18 Petroleum Generator Sets Mounting and Dismounting
C1.5 and C2.2 Marine Generator Set Engines Heat Exchanger - Install
C1.5 and C2.2 Generator Generator - Remove
C1.5 and C2.2 Marine Generator Set Engines Heat Exchanger - Disassemble
G3520B Industrial Engine Ignition Transformers Secondary Circuit and Spark Plugs
C1.5 and C2.2 Marine Generator Set Engines Heat Exchanger - Remove
C1.5 and C2.2 Marine Generator Set Engines Heat Exchanger - Assemble
2003/05/01 New Cylinder Liner {1216}
2003/08/01 A Pin for the Rocker Shaft Is Now Available for Parts Service {1102}
3500B and 3500C Marine Propulsion Engines Electronic Display Module
3500 Marine Engines Accumulator Pressure - Test
3116 and 3126 Truck Engines Rocker Shaft - Disassemble
G3520B Industrial Engine PWM Sensor
2003/05/12 New Front Crankshaft Seals and New Rear Crankshaft Seals are Now in Production {1160, 1161}
3116 and 3126 Truck Engines Rocker Shaft - Assemble
3116 and 3126 Truck Engines Rocker Shaft and Pushrod - Install
2003/05/05 New QuickEvac High Speed Oil Change Arrangements Are Available {1325}
C4.4 (Mech) Industrial Engine Glow Plugs - Test
3500B and 3500C Marine Propulsion Engines System Overview