Inlet Manifold - Install
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
Illustration 1 | g00707340 |
- Inspect the condition of the gaskets. Replace the gaskets, if necessary.
- Position air inlet manifold (6) and the gaskets on the cylinder head.
- Install bolts (7) and the washers. Tighten bolts (7) to a torque of
55 ± 10 N·m (40 ± 7 lb ft) . - Install hose assembly (5).
- Connect harness assembly (2).
- Install clip (4) and bolt (1). Tighten bolt (1) to a torque of
12 ± 3 N·m (9 ± 2 lb ft) . - Connect harness assembly (3).
Caterpillar Information System:
3176C and 3196 Engines For Caterpillar Built Machines Inlet Manifold - Remove
3176C and 3196 Engines For Caterpillar Built Machines Water Outlet Manifold - Install
3176C and 3196 Engines For Caterpillar Built Machines Water Outlet Manifold - Remove
3406E and 3456 Engines for Caterpillar Built Machines Crankshaft Rear Seal - Install
3304B and 3306B Engines for Caterpillar Built Machines Vibration Damper and Pulley - Remove and Install
3406E On-Highway Engine Crankshaft Rear Seal - Remove
3176C and 3196 Engines For Caterpillar Built Machines Lifter Group - Remove and Install
3306B Industrial Engine Tachometer Drive - Remove and Install
3176C and 3196 Engines For Caterpillar Built Machines Rocker Shaft and Pushrod - Install
3406E On-Highway Engine Flywheel - Install
3176C and 3196 Engines For Caterpillar Built Machines Rocker Shaft and Pushrod - Remove
3176C and 3196 Engines For Caterpillar Built Machines Valve Mechanism Cover Base - Remove and Install
3406E On-Highway Engine Gear Group (Front) - Remove
3406E On-Highway Engine Engine Oil Pan - Remove and Install
3612 and 3616 Engines Manual Valve Group (Cylinder Pressure)
3116 and 3126 Marine Engines Refill Capacities
G3300 Engines Engine Crankcase Breather - Clean
3116 and 3126 Marine Engines Reference Material
3612 and 3616 Engines Compression Release Valve
3176C and 3196 Engines for Caterpillar Built Machines Camshaft Bearings - Remove and Install
3406E On-Highway Engine Inlet and Exhaust Valve Seals - Remove and Install
G3300 Engines Ignition System Timing - Check/Adjust
3406E Truck Engine Vibration Damper
3176C and 3196 Engines For Caterpillar Built Machines Engine Oil Pan - Remove and Install