Engine Oil Level - Check
Show/hide table
 |
|
Hot oil and hot components can cause personal injury. Do not allow hot oil or hot components to contact skin. |
Show/hide table
| NOTICE |
|---|
|
Do not under fill or overfill engine crankcase with oil. Either condition can cause engine damage. |
Refer to the Operation and Maintenance Manual, "Access Doors and Covers" for the location of the service points.
Clean the area around the dipstick and clean the area around the oil filler cap before you remove the dipstick and before you remove the oil filler cap.
- Open the left side engine compartment door.
Show/hide table
Illustration 1 g00937462 - Before starting the engine, check the "ENGINE STOPPED" side of dipstick (1). Maintain the oil level between the "ADD" mark and the "FULL" mark.
- Remove oil filler cap (2). If necessary, add oil.
- Clean the oil filler cap and install the oil filler cap.
- Close the left side engine compartment door.
Caterpillar Information System:
914G Compact Wheel Loader and IT14G Integrated Toolcarrier Transmission Electronic Control System Diagnostic Capabilities
CP-433E, CS-423E and CS-433E Paving Compactors Platform Tilting
CB-634D Paving Compactor Engine Oil Sample - Obtain
416D, 420D, 424D, 428D, 430D, 432D, 438D and 442D Backhoe Loaders Hydraulic and Steering System Control Valve (Tilt) (Mechanically Operated) - Single Tilt Machines
CB-634D Paving Compactor Engine Oil Level - Check
CB-634D Paving Compactor Engine Mounts - Inspect
120H, 12H, 135H, 140H, 143H, 160H and 163H Motor Graders Initial Pressures - Test and Adjust
914G Compact Wheel Loader and IT14G Integrated Toolcarrier Transmission Electronic Control System Service Tools
C0.5, C0.7, C1.1/3011C, C1.5/3013C, C1.6 and C2.2/3024C/3024CT Industrial Engines and Engines for Caterpillar Built Machines Engine Design
CP-433E, CS-423E and CS433E Vibratory Soil Compactors Machine Systems Padded Drum Scraper - Flexible Scrapers
PM-465 Cold Planer Reference Material
CP-433E, CS-423E and CS-433E Vibratory Compactors Machine Systems Axle (without Brakes) - Assemble
CB-634D Paving Compactor Engine Oil and Filter - Change
570B Wheel Harvester and 580B Wheel Harvester Engine Supplement Refrigerant Compressor - Remove and Install
CB-634D Vibratory Compactor Machine Systems Steering Frame Lock - Separate and Connect
16H Motor Grader Engine Oil Sample - Obtain
16H Motor Grader Engine Oil and Filter - Change
CB-634D Paving Compactor Engine Water Pump - Inspect
CB-634D Vibratory Compactor Machine Systems Hydraulic System Pressure - Release
914G Compact Wheel Loader and IT14G Integrated Toolcarrier Transmission Electronic Control System Using the Diagnostic Indicator to Determine Diagnostic Codes
CB-634D Vibratory Compactor Machine Systems Battery and Battery Cable - Separate and Connect
CB-634D Paving Compactor Fuel System - Prime
C0.5, C0.7, C1.1/3011C, C1.5/3013C, C1.6 and C2.2/3024C/3024CT Industrial Engines and Engines for Caterpillar Built Machines Engine Oil Pressure - Test
416D Backhoe Loader Backhoe Stabilizer Controls