Required Tools | |||
---|---|---|---|
Tool | Part Number | Part Description | Qty |
A | 1U-8233 | Nylon Lifting Sling | 1 |
At operating temperature, the hydraulic tank is hot and under pressure. Hot oil and components can cause personal injury. Do not allow hot oil or components to contact skin. Remove the filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand. Remove the filler cap slowly in order to relieve pressure. |
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products. Dispose of all fluids according to local regulations and mandates. |
- Use Tooling (A) to position hoist cylinder (1) in order to attach bolts (2) and the washers. The hoist cylinder has a weight of
154 kg (340 lb) plus any hydraulic fluid in the cylinder.Note: Spacer plates may have been removed at disassembly. If the spacer plates were removed, install the spacer plates between the rear frame and the mount for the hoist cylinder.
Show/hide tableIllustration 2 g00514684 - Attach hoses (3) to the hoist cylinder with retaining nuts (4).
Show/hide table
Illustration 3 g00514704 - Install pin (5) through bracket (6) and through the hoist cylinder.
- Install bolt (7) and the washer. Install grease fitting (8). Make sure that grease is in the pivot.
Illustration 1 | g00514679 |