312C, 315C, 318C, 319C, 320C, 321C, 322C, 325C, 330C and M325C Excavators and 325C MHPU and 330C MHPU Mobile Hydraulic Power Units Engine and Pump Control - V2 Caterpillar


Device Test

Usage:

322C ADX
此功能使调速器和各种比例减压阀具有最大的扫描输出和固定输出。 可以对各种比例减压阀和指示灯的输出进行测试。 此功能允许激活每个部件来确认部件的工作。



    图 1g00778696

    显示类型

  1. 进入维修模式。 利用箭头键选择第二行。



    图 2g00689535

  1. 利用箭头键在显示中滚动找到 "DEVICE TEST(设备测试)"。



    图 3g00689541

  1. 第三行显示了所测试部件的名称。 上图显示了访问固定发动机转速模式的屏幕。 表 1 内显示了可以测试的项目列表。

    表 1
    设备测试的项目列表    
    设备名称     内容    
    "ENG SPEED-FIXED"     发动机转速的固定输出    
    "ENG SPEED-SWEEP"     发动机转速的扫描输出    
    "PS PRV-FIXED"     动力换挡压力的固定输出    
    "PS PRV-SWEEP"     动力换挡压力的扫描输出    
    "NFC1 PRV-FIXED"     流量极限压力(辅助)的固定输出    
    "NFC1 PRV-SWEEP"     流量极限压力(辅助)的扫描输出    
    NFC1 FLOW-FIXED     流量极限压力的流量固定输出    
    NFC1 FLOW-PRESS     输送压力设定值    
    2P FLOW-FIXED     流量控制比例减压阀的 2 泵流量固定输出    
    2P FLOW-PRESS     2 泵流量输出固定时,流量计算的输送压力设定值    
    1P FLOW1-FIXED     流量控制比例减压阀的 1 泵流量(f2 阀)固定输出    
    1P FLOW1-PRESS     1 泵(f2 阀)流量固定时,流量计算的输送压力设定值    
    1P FLOW2-FIXED     流量控制比例减压阀的 1 泵流量(f2 阀)固定输出    
    1P FLOW2-PRESS     1 泵(f2 阀)流量固定时,流量计算的输送压力设定值    
    "AEC LAMP-ON/OFF"     AEC 模式指示灯的输出    
    "TRV LAMP-ON/OFF"     指示灯行驶模式的输出    
    "A CANCEL-ON/OFF"     行驶报警解除指示灯的输出    
    "TRV SPEED-ON/OFF"     行驶速度电磁阀的输出    
    "TRV STR-ON/OFF"
    312C/ 315C 上未配备    
    直线行驶电磁阀的输出    
    "SWING BRK-ON/OFF"     回转停车制动器释放电磁阀的输出    

    注: 关于未列出的设备测试,请参阅所维修机器机具控制的对应维修手册。




    图 4g00689548

  1. 要想修改输出值,利用箭头键选择显示的第四行。



    图 5g00689551

  1. 选择第四行后按 "OK" 键。 第四行的显示将变为数值。 可以利用箭头键增加和降低数值。



    图 6g00689643

  1. 选择第四行的同时按 "cancel" 键可退出此模式。 退出模式后,上图将出现。



    图 7g00689647

  1. 要想在固定输出和扫描输出间切换,利用 "menu(菜单)"键在选定的区域间移动。 请参见上表。



    图 8g00689650

  1. 选择第四行后按 "OK" 键。



    图 9g00689651

  1. 按 "setting(设定)"键可以在 ON 和 OFF 之间切换扫描输出的状态。



    图 10g00689656

  1. 在选定第四行的同时按 "cancel(取消)"键可以退出固定输出模式。 当显示如上图中所示时,说明此模式已被取消。



    图 11g00689658

  1. 如果显示的第四行出现以下错误,则表明设备测试中出现了错误。 关于错误代码的详情,请参阅下表。

    表 2
    设备测试的错误代码    
    显示     错误说明     修正措施    
    错误 01     正由其他设备标定     停止其他设备正在执行的标定。 重新执行标定。    
    错误 02     正由其他模块标定     停止其他模块正在执行的标定。 重新执行标定。    
    错误 03     联锁信号故障     对到监视器的通信信号进行故障诊断与排除。    
    错误 21     部件工作异常     确认处于激活状态的错误代码。 根据处于激活状态的错误代码进行故障诊断与排除。    

Caterpillar Information System:

CB-534C Vibratory Compactor Engine Oil Sample - Obtain
Caterpillar<COMP-BREAK TAGNAME=cp850>©<COMP-RESUME> AP-900B and Barber-Greene<COMP-BREAK TAGNAME=cp850>©<COMP-RESUME> BG-240C Asphalt Pavers Conveyor Systems Piston Pump (Conveyor)
Caterpillar<COMP-BREAK TAGNAME=cp850>©<COMP-RESUME> AP-900B and Barber-Greene<COMP-BREAK TAGNAME=cp850>©<COMP-RESUME> BG-240C Asphalt Pavers Conveyor Systems Conveyor Hydraulic System
Caterpillar<COMP-BREAK TAGNAME=cp850>©<COMP-RESUME> AP-900B and Barber-Greene<COMP-BREAK TAGNAME=cp850>©<COMP-RESUME> BG-240C Asphalt Pavers Conveyor Systems Conveyor Planetary Drive (Auger)
Caterpillar<COMP-BREAK TAGNAME=cp850>©<COMP-RESUME> AP-900B and Barber-Greene<COMP-BREAK TAGNAME=cp850>©<COMP-RESUME> BG-240C Asphalt Pavers Conveyor Systems Piston Motor (Auger Conveyor)
Caterpillar<COMP-BREAK TAGNAME=cp850>©<COMP-RESUME> AP-900B and Barber-Greene<COMP-BREAK TAGNAME=cp850>©<COMP-RESUME> BG-240C Asphalt Pavers Conveyor Systems Auger Conveyor
988G Wheel Loader Machine Systems Piston Pump (Hydraulic Fan) - Assemble
988G Wheel Loader Machine Systems Piston Pump (Hydraulic Fan) - Disassemble
8-16B, 10-20B and 10-20WB Extend-A-Mat<COMP-BREAK TAGNAME=cp850>©<COMP-RESUME> Screed Screed Plate Leveling
14H Motor Grader Hydraulic System Oil Level - Check
TH103 Telehandler Refill Capacities
2000/04/03 A New Electronic Solenoid Valve Improves the Release of Auxiliary Hydraulic Pressure {5130, 5264, 5479}
3064 and 3066 Engines for Caterpillar Built Machines Cooling System - Check - Overheating
120H Motor Grader Hydraulic System Oil Level - Check
2000/03/27 Procedure to Enter the Correct Password for the Calibration Procedure on the Payload Control System (PCS) {7494}
2000/06/05 A New O-ring Seal is Used on the Brake Housing Assembly of Wheel Harvesters {4351}
777D and 777D HAA Off-Highway Truck and 776D Off-Highway Tractor Magnetic Screen (Transmission) - Clean
777D and 777D HAA Off-Highway Truck and 776D Off-Highway Tractor Oil Filter (Parking Brake Release) - Replace
777D and 777D HAA Off-Highway Truck and 776D Off-Highway Tractor Oil Filter (Steering) - Replace
777D and 777D HAA Off-Highway Truck and 776D Off-Highway Tractor Oil Filter (Torque Converter) - Replace
Ultrasonic Testing Procedure for Brake Bands{5405} Ultrasonic Testing Procedure for Brake Bands{5405}
CB-534C Vibratory Compactor Hydraulic System Oil - Change
777D and 777D HAA Off-Highway Truck and 776D Off-Highway Tractor Oil Filter (Transmission) - Replace
777D HAA Off-Highway Truck Screen (Torque Converter Sump) - Clean
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.