950G Wheel Loader, 962G Wheel Loader and IT62G Integrated Toolcarrier Engine Supplement Caterpillar

Removal Procedure

Start By:

1. Connect the steering frame lock. Refer to Disassembly and Assembly, "Steering Frame Lock - Separate and Connect".
2. Release the hydraulic system pressure. Refer to Disassembly and Assembly, "System Pressure - Release".

Note: Put identification marks on the hose assemblies for installation purposes. Plug the hose assemblies. This will help to prevent fluid loss and this will help to keep contaminants from entering the system.

Note: The hydraulic oil cooler is mounted on the radiator assembly inside the hood.

1. Open the engine hood.

Show/hide table



Illustration 1	g00355316

2. Disconnect hydraulic hose assemblies (1) and (2) from the hydraulic oil cooler.

Show/hide table



Illustration 2	g00355317

3. Remove bolts (3) .

Show/hide table



Illustration 3	g00355318

4. Remove bolts (5). Remove hydraulic oil cooler (4) .

Installation Procedure

Show/hide table



Illustration 4	g00355318

1. Install hydraulic oil cooler (4) and bolts (5) .

Show/hide table



Illustration 5	g00355317

2. Install bolts (3) .

Show/hide table



Illustration 6	g00355316

3. Connect hydraulic hose assemblies (1) and (2) to the hydraulic oil cooler.

4. Close the engine hood.

5. Fill the hydraulic tank to the proper level. Refer to Operation and Maintenance Manual, SEBU7018, "Hydraulic System Oil - Change" for the correct procedure.

End By: Separate the steering frame lock. Refer to Disassembly and Assembly, "Steering Frame Lock - Separate and Connect".