Drive Shaft Spline (Center) - Lubricate
Wipe the grease fitting before you lubricate the grease fitting.
Show/hide table
NOTICE |
---|
To prevent damage to the seal, fully articulate the machine to the right or to the left, before lubricating the spline. |
- Start the engine. Raise the bucket. Release the parking brake. Fully articulate the machine to the left or to the right.
- Lower the bucket to the ground. Engage the parking brake. Stop the engine.
- Apply lubricant to the grease fitting that is on the drive shaft spline.
Show/hide table
Illustration 1 | g00101824 |
- Start the engine. Raise the bucket. Release the parking brake. Articulate the machine until the machine is straight.
- Lower the bucket until the bucket exerts a slight downward pressure on the ground. Stop the engine. Engage the parking brake.
Caterpillar Information System:
966G and 972G Wheel Loaders Power Train Relief Valve (Torque Converter Outlet) - Disassemble
938G Wheel Loader and IT38G Integrated Toolcarrier Power Train NoSPIN Differential
785C HAA Off-Highway Truck Engine Air Filter Primary Element - Clean/Replace
784C and 785C Off-Highway Truck/Tractors Drive Shaft Slip Joint - Lubricate
CP-563D, CS-563D, CS-573D and CS-583D Paving Compactors Vibratory Support Oil Sample - Obtain
CP-563D, CS-563D, CS-573D and CS-583D Paving Compactors Vibratory Support Oil Level - Check
CP-563D, CS-563D, CS-573D and CS-583D Paving Compactors Vibratory Support Oil - Change
966G and 972G Wheel Loaders Power Train Transmission Oil Pump - Assemble
938G Wheel Loader and IT38G Integrated Toolcarrier Power Train Limited Slip Differential Disc End Play Check - Check
517 Track-Type Skidder Hydraulic System Hydraulic Tank and Filter
CP-563D, CS-563D, CS-573D and CS-583D Paving Compactors Tire Inflation Pressure Adjustment
966G and 972G Wheel Loaders Power Train Transmission Oil Pump - Disassemble
IT14G Integrated Toolcarrier and 914G Wheel Loader Braking System Brake System Air - Purge
966G and 972G Wheel Loaders Power Train Relief Valve (Torque Converter Outlet) - Assemble
928G Wheel Loader Steering Cylinder Bearings - Lubricate
938G Wheel Loader and IT38G Integrated Toolcarrier Power Train Bevel Gear and Pinion (Fixed and Oscillating Axles)
3126B Engine for Caterpillar Built Machines Cylinder Head
966G and 972G Wheel Loaders Power Train Relief Valve (Transmission Hydraulic Control) - Remove
966G and 972G Wheel Loaders Power Train Relief Valve (Transmission Hydraulic Control) - Install
785C HAA Off-Highway Truck Engine Air Filter Service Indicator - Inspect
785C HAA Off-Highway Truck Engine Oil Level - Check
785C HAA Off-Highway Truck Engine Oil and Filter - Change
IT14G Integrated Toolcarrier and 914G Wheel Loader Machine Systems Tilt Cylinder - Remove
793B Off-Highway Truck Front Axle Breather - Replace