Stopping the Engine
Show/hide table
| NOTICE |
|---|
Stopping the engine immediately after it has been working under load, can result in overheating and accelerated wear of the engine components. Refer to the following procedure, to allow the engine to cool, and to prevent excessive temperatures in the turbocharger housing (if equipped), which could cause oil coking problems. |
- Operate the engine for five minutes at low idle with no load.
This allows hot areas in the engine to cool gradually. This will extend the engine life.
- Turn the engine start switch key to the OFF position in order to stop the engine.
Show/hide table
 | |
| Illustration 1 | g00101775 |
- Move all hydraulic control levers back and forth in order to relieve hydraulic pressure.
- Move all hydraulic control levers into the HOLD position.
- Move the hydraulic lock lever to the LOCKED position.
Show/hide table
 | |
| Illustration 2 | g00432844 |
Caterpillar Information System:
517 Track-Type Skidder Power Train Transmission and Torque Converter Pump
IT14G Integrated Toolcarrier and 914G Wheel Loader Machine Systems Coupler Cylinder - Assemble
950G Wheel Loader, 962G Wheel Loader and IT62G Integrated Toolcarrier Steering System Steering Neutralizer Valve
65E, 75E, 85E and 95E Agricultural Tractors S·O·S Oil Analysis
924Gz Wheel Loader Parking Brake Control
IT14G Integrated Toolcarrier Material Handling Arm Rated Load
IT14G Integrated Toolcarrier and 914G Wheel Loader Machine Systems Coupler Cylinder - Disassemble
65E, 75E, 85E and 95E Agricultural Tractors Cold Weather Lubricants
65E, 75E, 85E and 95E Agricultural Tractors Lubricating Grease
517 Track-Type Skidder Power Train Torque Converter
65E, 75E, 85E and 95E Agricultural Tractors Aftermarket Oil Additives
65E, 75E, 85E and 95E Agricultural Tractors Re-refined Base Stock Oils
561M Pipelayer Resonator Assembly
924Gz Wheel Loader Stopping the Machine
517 Track-Type Skidder Power Train Transmission Oil Filter
IT14G Integrated Toolcarrier and 914G Wheel Loader Braking System Braking System Troubleshooting
CP-563D, CS-563D and CS-583D Vibratory Compactors Leveling Blade Control Valve
572R Pipelayer Lifting Capacities
IT14G Integrated Toolcarrier and 914G Wheel Loader Machine Systems Seat - Remove and Install
517 Track-Type Skidder Power Train Transmission - Power Shift
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Housing (Front)
517 Track-Type Skidder Power Train Bevel and Transfer Gears
517 Track-Type Skidder Power Train Drive Shaft
CP-563D, CS-563D and CS-583D Vibratory Compactors Leveling Blade Hydraulic Oil Filter