Starting Above 0°C (32°F)
Show/hide table
Illustration 1 | g00382313 |
- Move the transmission directional control lever to the NEUTRAL position.
- Use the engine start switch key (1) in order to unlock the parking brake. The parking brake switch (2) must be ENGAGED .
Show/hide table
Illustration 2 | g00100349 |
- Move the hook control lever, the boom control lever, and the counterweight control lever to the HOLD position.
Show/hide table
Illustration 3 | g00382612 |
- Turn the battery disconnect switch to the ON position. The battery disconnect switch is inside the battery compartment. Open the small access door in order to gain access to the switch.
Show/hide table
Illustration 4 | g00380292 |
- Return the governor control lever to the LOW IDLE position.
- Turn the key start switch to the ON position. The system performs an automatic self-test. When you turn on the start switch key the test is performed. If the test is complete without any faults, proceed to next step. If the system detects a fault, check the electrical system. Make all of the necessary repairs before you start the engine.
Show/hide table
Illustration 5 | g00382352 |
- The engine oil pressure light should turn on, and the alternator light should turn on.
Show/hide table
Illustration 6 | g00382353 |
- Turn the start switch key to the START position. Crank the engine. Release the key when the engine starts.
Show/hide table
Illustration 7 | g00425497 |
Show/hide table
NOTICE |
---|
Do not crank the engine for more than 30 seconds. Allow the starter to cool for two minutes before cranking again. Turbocharger damage can result if the engine rpm is not kept low until the oil gauge display verifies that the oil pressure is sufficient. |
Caterpillar Information System:
HH45 Harvester Head, HH55 Harvester Head, HH65 Harvester Head and HH75 Harvester Head Operating Technique Information
572R Pipelayer Power Train Track Rollers - Single Flange and Double Flange
789B Off-Highway Truck Refill Capacities
784B and 785B Off-Highway Truck/Tractors Refill Capacities
3406C Engines for Caterpillar Built Machines Cylinder Liner
572R Pipelayer Power Train Track Carrier Rollers
IT14G Integrated Toolcarrier Window Washer Reservoir - Fill
IT14G Integrated Toolcarrier V-Belts - Inspect/Adjust/Replace
3406E and 3456 Industrial Engines Fan Drive
789B Off-Highway Truck Automatic Retarder
784B and 785B Off-Highway Truck/Tractors Automatic Retarder
HH45 Harvester Head, HH55 Harvester Head, HH65 Harvester Head and HH75 Harvester Head Walk-Around Inspection
572R Pipelayer Power Train Tracks
3406E Truck Engines Piston and Rings
HH45 Harvester Head, HH55 Harvester Head, HH65 Harvester Head and HH75 Harvester Head Roading
793B Off-Highway Truck Power Train Torque Converter Lockup Clutch Primary Pressure - Test and Adjust
3406E and 3456 Industrial Engines Coolant Level Sensor
572R Pipelayer Starting Below 0°C (32°F) with Ether Starting Aid
3406E and 3456 Industrial Engines Engine Support (Front)
65E, 75E, 85E and 95E Agricultural Tractors Alternator and Fan Belts - Inspect/Adjust/Replace
572R Pipelayer Power Train Recoil Group
C4.4 (Mech) Industrial Engine Troubleshooting
789C Off-Highway Truck Power Train Differential and Bevel Gear - Adjust
CP-563C and CS-563C Vibratory Compactors Engine Mounts - Inspect