IT14G Integrated Toolcarrier Caterpillar

Investigate the travel route for overpass clearances. Make sure that there will be adequate clearance if the machine that is transported is equipped with a ROPS, with a cab, or with a canopy.

Remove ice, snow, or other slippery material from the loading dock and from the transport vehicle before you load the machine. This is done in order to prevent slippage of the machine. This should also be done in order to prevent a shift while the machine is moving in transit.

Show/hide table

NOTICE
Obey all state and local laws governing the weight, width and length of a load. Make sure the cooling system has proper antifreeze if moving machine to a colder climate. Observe all regulations governing wide loads.

Show/hide table

Illustration 1	g00040011

1. Chock the trailer or rail car wheels before you load the machine.

2. After the machine is positioned, connect the steering frame lock link in order to hold the front frame and the rear frame in place.

   Reference: For more information, refer to Operation and Maintenance Manual, "Steering Frame Lock".

3. Lower the work tool to the floor of the transport vehicle. Move the direction control lever or move the direction control switch (if equipped) to NEUTRAL.

4. Engage the parking brake.

5. Turn the engine start switch key to OFF and remove the key.

6. Move all of the hydraulic control levers in order to relieve any trapped pressure.

7. Move the hydraulic lockout lever to the LOCKED position.

8. Turn the battery disconnect switch key (if equipped) to OFF and remove the key.

9. Lock the door and the access covers. Attach any vandalism protection.

10. Secure the machine, equipment and any tools with tie-downs in order to prevent movement during shipping.

    Reference: For more information, refer to Operation and Maintenance Manual, "Lifting and Tying Down the Machine".

11. Cover the exhaust opening. The turbocharger (if equipped) should not rotate when the engine is not operating. Damage to the turbocharger can result.