Transmission Oil - Change
Operate the machine for a few minutes in order to warm the transmission oil.
The machine should be level. Lower the bucket to the ground and apply slight downward pressure. Engage the parking brake and stop the engine.
Show/hide table
Illustration 1 | g00107038 |
- Remove the transmission drain plug. Allow the transmission oil to drain into a suitable container. Clean the transmission drain plug and install the transmission drain plug.
- Change the transmission oil filter element. Refer to Operation and Maintenance Manual, "Transmission Oil Filter - Replace".
- Clean the transmission magnetic screen. Refer to Operation and Maintenance Manual, "Transmission Magnetic Screen - Clean".
- Remove the engine access door on the left side of the machine.
Show/hide table
Illustration 2 | g00105081 |
- Remove the dipstick/fill cap and fill the transmission with transmission oil. Refer to Operation and Maintenance Manual, "Lubricant Viscosities" and Operation and Maintenance Manual, "Refill Capacities".
Show/hide table
Illustration 3 | g00107039 |
- Start the engine and run the engine at low idle. Apply the service brake. Slowly operate the transmission controls in order to circulate the oil.
- Move the transmission control lever to NEUTRAL and engage the parking brake. Inspect the transmission for leaks.
- Maintain the transmission oil level between the "ADD" mark and the "FULL" mark on the dipstick when the transmission is warm. Add transmission oil through the transmission filler tube, if necessary.
- Install the dipstick/fill cap and install the engine access door.
- Stop the engine.
Caterpillar Information System:
446B Backhoe Loader Transmission Neutral Lock Control
446B Backhoe Loader Transmission Direction and Speed Control
446B Backhoe Loader Towing the Machine
446B Backhoe Loader Tire Shipping Pressure
143H and 163H Motor Graders Air System and Brakes Front Wiring
416C, 426C, 428C, 436C and 438C Backhoe Loaders Tire Inflation with Air
446B Backhoe Loader Tire Inflation - Check
446B Backhoe Loader Swing Lock Pin Control
446B Backhoe Loader Swing Frame and Cylinder Bearings - Lubricate
446B Backhoe Loader Transmission Magnetic Screen - Clean
446B Backhoe Loader Stopping the Machine
446B Backhoe Loader Stopping the Engine
446B Backhoe Loader Transmission Oil Filter - Replace
446B Backhoe Loader Transmission Oil Level - Check
446B Backhoe Loader Transport Position
446B Backhoe Loader Travel Speed
416C, 426C, 428C, 436C and 438C Backhoe Loaders Walk-Around Inspection
446B Backhoe Loader Walk-Around Inspection
446B Backhoe Loader Warning Signs and Labels
446B Backhoe Loader Wheel Bearings (Front) - Lubricate
446B Backhoe Loader Wheel Nut Torque - Check
143H and 163H Motor Graders Air System and Brakes Service Brake Control
143H and 163H Motor Graders Air System and Brakes Service Brake Control
446B Backhoe Loader Windows - Clean