Usage:
1. Lift the hoods, and fasten them in position with the hood locks.
2. Disconnect hose (1) at governor control cylinder (2).
3. Remove pin (4).
4. Remove governor control cylinder (2).
5. Note the position of linkage (3) in the lever, and remove linkage (3).
NOTE: The following steps are for installation of the governor control cylinder.
6. Adjust linkage (3) so the distance between rod end centers is 84.07 mm (3.309 in).
7. Install linkage (3) in its original position in the lever.
8. Be sure lever (5) on the governor shaft is at 15 degrees from vertical (counter clockwise when viewed from the left side of the machine) with engine at low idle.
9. Install control cylinder (2). Install pin (4) through link (3) and lever (5).
10. Connect hose (1) to governor control cylinder (2).
11. Adjust linkage (3) so lever (5) is at low idle when governor control cylinder is fully retracted.
12. Lower the hoods.
End By:
a. remove body support (FT1437) or body retaining pins