All Size Identification Marks On Engine Bearings Are Now Shown In Millimeters{1000,1230,1219,1203}
Usage:
All Caterpillar Engines
An earlier article told about the start of a gradual change to the use of millimeters instead of inches for size identification marks on engine main and connecting rod bearings. This metric conversion is now complete, and all size identification marks on engine bearings are now shown in millimeters. The chart shows a comparison of millimeter to inch dimensions for different sizes of bearings. These dimensions are shown on all oversize (larger than standard size) and/or undersize (smaller than standard size) bearings, with the letters OS (for oversize) or US (for undersize) or both. Some, but not all, bearings have the letters mm after the dimension to show that the size is given in millimeters.
Caterpillar Information System:
1981/07/06 Mailing Of Engine News And Truck Engine News Microfiche Libraries{0374}
1981/07/06 New Turbocharger, Turbocharger Oil Line And Aftercooler Air Lines Group Used{1052}
1981/07/06 Specifications For Reconditioning Of Final Drive Inner And Outer Housings{4052,4059,4062}
1981/07/06 6V3176 Relief Valve Available For Center Hole Double Acting Hydraulic Cylinders{0623}
1981/06/29 New Gasket Used For End Cover On Inlet Manifold{1058}
1981/06/29 New Inlet Lines To Radiator Permit Easier Assembly{1353,1380}
1981/06/29 Use 6V4828 Snap Ring Pliers To Remove Snap Rings From Turbocharger Housing{0610,1052}
1981/06/29 New Inlet And Exhaust Valves And Valve Guides Have Tighter Fit To Prevent Corrosion And Guide Wear{1104,1105,1101,1103,1108,1109}
1981/06/29 Coolant Flow Circuit Can Be Added To The Electronic Monitoring System (EMS){7490,1380,1375,1350}
1981/06/29 Changes Made To Brake Lines And Brake Oil Cooler Lines{4257,1365,5057}
1981/06/29 New Gasket Used In Front Housing Group{1166,1162,1151}
1981/06/29 Ring Now Used To Hold Bearing In Auxiliary Drive Group{1165}
1981/07/06 Single Connector Prevents Leakage From Fuel Filter Lines Groups{1274,1262}
1981/07/06 Use 6V4068 Tool Group To Machine Camshaft Thrust Face{0663,1253}
1981/07/13 Add New Information To Two Current Guidelines For Reusable Parts{0374}
1981/07/13 Use 6V4805 Valve Seat Extractor Group To Remove Valve Seat Inserts{0621}
1981/07/13 Top Rings For Pistons Have Two Designs{1215,1214}
1981/07/13 Coolant Conditioner Elements And Their Capacities{1350}
1981/07/13 New Circle Guide Shoes Can Be Adjusted For Better Control Of Clearance Between Circle Teeth And Drive Pinion{6155,6153}
1981/07/13 Remove Piston Cooling Tubes Before Removal Of Pistons And Connecting Rods{1214,1218,1201,1225,1307}
1981/07/13 Washer, Seal Added To Improve Oil Filter Assembly{1306,1318}
1981/08/03 New Hydraulic Accumulator Group Used In The Steering System{4300,5077}
1981/08/03 Delay Expected In Replacement Of Canceled Service Tools{0651}
1981/08/03 New Circle Drive Shaft{5237}